Page 1
10/2021 Mod: ADD-60/MX2 Production code: TT 50 EI...
Page 2
AUTOMATIC WATER SOFTENER STATION ADD-60/MX2 Please read the operating manual before startup! The manufacturer is not responsible for malfunctions caused by faulty operation and failure to comply with the provisions of this documentation. Store for later use! This operating manual is an integral part of the device.
Table of contents General instructions..........................3 Transportation and packaging ......................... 3 Liability Exclusion ..........................3 How it works ............................4 Standards, provisions and statutory regulations ..................4 1. Description of the device ........................4 1.1 System structure .......................... 4 1.2 Technical description ......................... 4 1.3 Control function ...........................
General instructions 1. The relevant installation and operation instructions contained in this manual must be read prior to the installation and operation of this device. 2. The manufacturer will not bear responsibility in case of improper use and incorrect operation of the device.
1. Description of the device 1.1. System structure The system of water purification type ADD-60/MX2 is a device of high quality and precision. Properly installed and maintained guarantees infallible functioning for many years. The water softener station of small efficiency type ADD-60/MX2 is used where the water flow does not exceed 45l/min.
Page 6
TAB. 1. Programming – ADD-60/MX2 System efficiency programming is about to entering the feed water hardness value in German degrees to control valve. The system will automatically calculate the capacity for the programmed hardness. Water Hardness French German degree degrees...
1.3. Control function Steering Valve Before starting, you should program the time and frequency of regeneration. The controller is factory programmed for regeneration at 2.00 at night, for 20 oGH. Depending on water hardness program the value in valve. 2. Preparation for installation 2.1.
3. Installation After preparation for mounting, the device is to be placed in the designated room in accordance with the system structure. All inlets and outlets are to be connected on the water’s side. The device connections are shown in the following figure: ·...