Advertisement
DRYWALL INSTALLATION
INSTRUCTIONS
**IMPORTANT** For safety reasons, this
mount must be secured to a wood stud
capable of supporting the combined weight
of the mount and display. **DO NOT MOUNT
TO DRYWALL ALONE**
1. Use a high quality stud fi nder to locate the
stud where you wish to install your mount.
Mark both edges of the stud to help identify
the exact center.
**NOTE**: You must use the center of each
stud to avoid cracking or splitting the wood
during installation.
2. Place the wall plate against the wall and
level it using the integrated bubble level.
3. While another person holds the wall plate in
position, mark three locations for securing
the mount to the wall (See Fig. 1).
FIG. 1
4. Drill a 1/8" (3mm) pilot hole at each
marked location.
5. Place the wall plate back against the wall
and attach it using the drywall screws (A)
provided in the hardware kit (see Fig. 2)
FIG. 2
CONCRETE INSTALLATION
INSTRUCTIONS
**IMPORTANT** For safety reasons, the
concrete wall must be capable of supporting
the combined weight of the mount and the
display. The seller/manufacturer takes no
responsibility for the failure caused by walls
or insuffi cient strength.
**IMPORTANT** If installing the mount into
a concrete block or brick surface, never drill
into the mortar between blocks or bricks.
YOU MUST SECURE THE MOUNT TO THE
CONCRETE BLOCK OR BRICK.
1. Place the wall plate against the wall in
the desired location and level it using the
integrated bubble level.
2. While another person holds the wall plate in
place, mark three evenly spaced locations
on the wall for securing the mount
(see Fig. 3).
3. Drill an 5/16"
(8mm) hole at
each marked
location.
Remove any
excess dust
from the holes.
4. Insert a concrete
anchor (B) into each
hole so that it is
fl ush with the concrete
surface (see fi g. 4).
A hammer can be
used to lightly
tap the anchors
into place if
necessary.
Do not over-
tighten these
screws.
Ensure that
the wall plate
remains level
after all screws
are secured.
3
FIG. 3
FIG. 4
Advertisement
