Page 1
ORIGINAL INSTRUCTIONS INSTRUCTIONS MANUAL SUBMERSIBLE PUMP 400W RAY400EPDW CAUTION: Read these instructions before use this appliance BUILDER 32, rue Aristide Bergès - ZI 31270 Cugnaux – France MADE IN PRC 2018...
1. SAFETY INSTRUCTIONS Please note that all instructions must be consulted! Failure to observe the following instructions and warnings may result in electric shock, fire and / or serious injury. Keep all instructions and warnings for future reference. If you are giving this device to another person, please provide this instruction manual as well.
Page 3
Disconnect the pump from the supply mains before carrying out user maintenance such as cleaning the filter. Pollution of the liquid could occur due to leakage of lubricants. The pump must not be used when people are in the water. Symbols Disposal (WEEE) Read the instruction manual...
1. Carrying handle 2. Supply cord 3. Water outlet 4. Water inlet 5. Floating switch 6. Motor housing b. Technical data Type RAY400EPDW Voltage / frequency 230V/50Hz Power input 400W Delivery rate max 7500 l/h Max total head Max operating depth max.
Water temperature max. 35° C 3. OPERATION a. Before use Remove all packing materials. Keep them out of the reach of children. There is a risk of accidents and suffocations if children play with plastic wrappings and bags. Check that the appliance, power cord, power plug and all accessories have not been damaged during transport and that the appliance is complete.
Page 6
d. Hose connection The pump is equipped with a universal fitting which allows connecting hoses of various sizes as listed below: Connection for hoses of Ø 13 mm / 15 mm / 19 mm: Cut off the topmost nipple on the universal fitting at the position ○ ,a. Screw a 25.4 mm tap adaptor onto the universal fitting.
Make sure that the distance between the float switch head and the latching holder is not too small. Proper operation is not guaranteed if the gap is too small. When you set the float switch, make sure that it does not touch the base before the pump switches off.
6. TROUBLESHOOTING Incidents Causes Remedies Pump does not start - No mains supply - Check mains supply - Floater does not switch - Bring floater in a higher position No flow - Inlet sieve is clogged - Clean inlet sieve water jet - Pressure hose in bent - Reset hose Pump does not switch off...