Related Manuals for Edis CS17-17
Summary of Contents for Edis CS17-17
- Page 1 Wifi Full Digital Conference System User Manual CS17-17 CS17-18 Before using this system, please read this manual carefully...
- Page 2 Notification WARNING To ensure the reliability of the equipment and the safety of personnel, please observe the following when installing, using and maintaining: ● If any of the following conditions are found, please immediately turn off the power, plug out and quickly contact your nearest dealer.
- Page 3 ● This product uses a power plug or appliance input socket as a disconnecting device with the power supply, and must be disconnected if necessary for safety reasons. ● This equipment is only suitable for safe use at altitudes under 2000meters. Precautions 1.
- Page 4 5. Agreement Please strictly follow the instructions in this manual. The software, hardware and appearance of this product will be upgraded and updated continually. The above changes will be made without notice. Non-professional maintenance personnel,do not remove the product, to avoid damage and electric shock.
-
Page 5: Table Of Contents
....................- 7 - RODUCT FUNCTION INTRODUCTION ..........................- 8 - 2.3. S PECIFICATION 3. System connection diagram......................- 9 - 4. CS17-17 CS17-18 Operating instructions................- 10 - 4.1. B ............................- 10 - ..........................- 10 - 4.2. U NIT TYPE ...................... -
Page 6: System Overview
The perfect combination of wireless network and wired digital products brings a new breakthrough change to the conference field. Product introduction CS17-17 CS17-18 4.3-inch WiFi conference chairman/delegate unit CS17-17 Chairman Unit CS17-18 Delegate Unit Feature 2.1. -
Page 7: Product Function Introduction
With a USB charging interface, it supports 18W fast charging. Support Chinese, English, Russian, French four language interface switching. Product function introduction 2.2. CS17-17 Chairman Unit: CS17-18 Delegate Unit: Microphone button (touch); 2.Chairman unit priority button (touch); 3.4.3-inch capacitive touch screen;... -
Page 8: Specification
Specification 2.3. Model CS17-17/CS17-18 Microphone type Cardioid directional electret microphone Frequency response 80Hz~16KHz Sensitivity -36±1.5dB (0dB=1V/Pa, at 1KHz) Max SPL 100dB(THD>3%) >80dB(A) Crosstalk >70dB Dynamic range >80dB <0.1% Speaker maximum output power Headphone output power/impedance 15mW / > 32ohm < 200ohm... -
Page 9: System Connection Diagram
System connection diagram - 9 -... -
Page 10: Cs17-17 Cs17-18 Operating Instructions
CS17-17 CS17-18 Operating instructions Boot 4.1. Turn on the power of the controller to start the conference system, and the controller will display on the screen"System Loading...", The page is as follows: After the boot, the touch screen displays the LOGO interface; enter the home page after... -
Page 11: Meeting Management
On the touch screen of the delegate unit, you can switch the microphone, switch between Chinese and English, and adjust the brightness. Meeting management 4.3. The microphone switch of the unit is controlled by the conference management, and its permission is configured by the conference controller. Refer to the controller's conference mode description for the logic of use. -
Page 12: Sign In
Press the priority button of the chairman unit to turn off the microphones of all delegate units. The chairman unit turns on the microphone delegate unit and the display is as follows: Sign in 4.4. The wired chairman machine or PC software initiates sign-in, and the corresponding light is on, and the display is as follows. -
Page 13: Vote
Vote 4.5. The wired chairman unit can initiate 3-button voting for fixed options; PC software can initiate 3-button voting for fixed options, 5-button elections for fixed options, 5-button ratings for fixed options, and custom options 2/3/4/5 key elections. The display is as follows: The 3-button voting process for fixed options: 3-button voting for fixed options, press the button to display accordingly: The 5-button election process for fixed options:... - Page 14 The 5-button election of fixed options will be displayed when the button is pressed: 5-button rating process for fixed options: The 5-button rating of the fixed options will be displayed when the button is pressed: Custom option 2/3/4/5 button election process: - 14 -...
-
Page 15: Fire Alarm
Custom option 2/3/4/5 button election, press the button to display correspondingly: Fire alarm 4.6. When the controller sends a fire alarm message, the controller screen will display"Fire warning"Prompt, the red light of the microphone pole will flash until the controller cancels the fire alarm and the controller resumes its pre-alarm state. -
Page 16: System Setting
System setting 4.8. Enter the system settings page, as shown in the figure below, there are language setting, backlight setting, system status and other functions. Language setting 4.9. Click the language setting button to enter the Chinese-English switching page to switch the four languages of Chinese, English, Russian, French, and save when power off. -
Page 17: Backlight Setting
Backlight setting 4.10. Click the backlight setting button to enter the backlight setting page, as shown in the figure below: System status page 4.11. Click the system status button to enter the query system, as shown bellow: MAC address: wireless network card MAC address. Network name: SSID of wireless AP, click to select a network. -
Page 18: Volume Adjustment
Volume adjustment 4.13. Click the volume button to enter the volume adjustment page, you can adjust the speaker output and headphone output at the same time, the volume adjustable range is 1 to 16, 16 is the maximum volume,Support power-off memory. Service application 4.14. -
Page 19: Wireless Ap Drop Detection Function
When the application item is selected, the software will prompt whether to send the application, if yes, send it, otherwise it will return. After sending the application, you can see the corresponding prompt on the PC, and the unit will also display the corresponding prompt. Wireless AP drop detection function 4.15. -
Page 20: Controller Offline Detection Function
Controller offline detection function 4.16. Turn off the power of the controller or the controller network cable fails for about 60 seconds, the interface will pop up the following dialog box. If the controller works normally, the interface will return to the main page. WIFI SSID and password modification 4.17. -
Page 21: Edit Id Function
Edit ID function 4.19. After the controller presses the Edit ID, it enters the Edit ID mode. At this time, press the set button or press the microphone button to set the ID. Speech countdown and speech timekeeping 4.20. This function needs to be controlled by the conference PC software. For details, please refer to the PC operating instructions. -
Page 22: Charge, Battery Level, Wifi Signal Strength, Charging Mode Indication
In the speech timekeeping, the PC designates the unit for speech timekeeping, and the unit accounting displays the speech time. Charge, battery level, WIFI signal strength, charging mode indication 4.21. WIFI signal strength, a total of 4 white bars, no signal means no icon: There are 4 bars in full charge, the icon is: The icon of the charging plug is Fast charge mode:... -
Page 23: Automatic Low-Battery Shutdown
Custom message: Automatic low-battery shutdown 4.23. When the battery is too low, the wireless controller will automatically shut down after prompting the following picture. Switch button function 4.24. In the shutdown state, short press the button to turn on the system. In the power-on state, long press the button for 3s, system shutdown. -
Page 24: Quick Charge Mode Description
Quick charge mode description 4.26. Type-C port supports USB Power Delivery (PD2.0/PD3.0) protocol, supports FCP/AFC/SFCP fast charge protocol. Compatible with BC1.2, Apple, Samsung mobile phone fast charge, etc.