Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Altra NT-AT
- Page 1 Electric Water Tape Dispenser Manual MODEL: NT-AT VERSION: 202101...
- Page 2 CONTENTS SAFETY NOTICE DISPENSER PARAMETERS STRUCTURE INTRODUCTION KEYPAD OPERATION INSTRUCTION ROLL GUIDE INSTALLATION INSTRUCTION TAPE INSTALLATION INSTRUCTION UPPER TAPE PLATE INSTALLATION INSTRUCTION BRUSH OPERATION INSTRUCTION WATER BOTTLE OPERATION INSTRUCTION MAINTENANCE INSTRUCTIONS...
- Page 3 SAFETY NOTICE Please use 200-230V power supply. Avoid placing in direct sunlight and outdoors. Please cut off the power quickly when break down. Please disconnect the power supply and remove the plug , when cleaning or repairing equipment. Do not disassemble or repair equipment without the knowledge of engineer. DISPENSER PARAMETERS Voltage Size...
- Page 4 STRUCTURE INTRODUCTION Top Cover Operating Guide 5.Water Bottle Brush Assembly Water Tank 2.Manual handle for shear blade 1.Roll guides 4.Drive wheel 3.Lower platen 5.Shear Blade 6.Heating equipment 7.Brush pressure adjusting device...
- Page 5 KEYPAD OPERATION INSTRUCTIONS Temperature Gear 18° Temperature Control button 36° 54° H: 0 without temperature. 72° H: 1-5 different temperature ranges. 90° AUTO Summer setting: H-3 \ Winter setting: H-5 Auto continuous mode Pressing the AUTO button, then press any value, the tape AUTO is dispensed, and the same length tape will be automatically dispensed.
- Page 6 ROLL GUIDE INSTALLATION INSTRUCTION According to the actual tape width, install the roll guides at its proper position. See Figure 1, Insert the upper part of the roll guide into the front slot. See Figure 2, Insert the lower end of the roll guide into the front slot. See Figure 3, Insert the roll guide into the bottom slot.
- Page 7 UPPER TAPE PLATE INSTALLATION INSTRUCTION Check the upper tape plate if is in its proper position. Install the Upper Tape Plate as shown below. BRUSH OPERATION INSTRUCTION As shown in Picture 1, first take out the water box to fill it with water, then take out the water tank.
- Page 8 WATER BOTTLE OPERATING INSTRUCTION Fill the bottle with water and place its proper position. The water level in the water tank can be adjusted at the positionshown in Figure 1. Normally, the water level is adjusted to the highest level. Caution: Pay attention to the amount of water remaining in the water bottle when using.
Need help?
Do you have a question about the NT-AT and is the answer not in the manual?
Questions and answers