COUNTERFLOW AI ThreatEye NetworkTraffic Recorder Installation, Quick Start

IN THE BOX

• ThreatEye NetworkTraffic Recorder Unit
TM
• Cable Management Kit
• Sliding Rails
• Power Cords
• Accessory Kit:
• PTP Time Synchronization Cable
• 4 Transceiver Modules (Dual Rate 1/10 Gbps)
• Product Information Guide
• CounterFlow AI Installation Quick Start (this guide)
• CounterFlow AI Software Licensing Agreement

SAFETY, COMPLIANCE, AND PRODUCT DISPOSAL

CLASS ONE LASER PRODUCT
Warning: This unit is fitted with optical transmitter
modules that are class 1 lasers. Use of controls,
adjustments or performance of procedures other than
those specified herein might result in hazardous
light exposure.
Read and take careful note of the guidelines in the
product information guide regarding:
• Safety and precautions that you should take during
the installation
• EMC compliance with FCC and other regulations
• Recycling and disposal of this product

UNPACK AND INSTALL HARDWARE

Unpack the ThreatEye
TM
information guide for details about unpacking the ThreatEye
The unit comes with sliding rails and a cable management arm for mounting into a standard 19-inch rack
system. We recommend installing all cables into the cable management arm to make it easier to access the
unit later without damaging the cables.
• Ensure that the ThreatEye
• Plug the transceiver modules into the capture network ports. Make sure that the latch is firmly
secured, and connect the fiber optic cable, if applicable. CAUTION. To avoid exposure to laser light, do not
remove the protective plugs from the transceiver modules until the fiber-optic cables are ready to be
connected. Retain and replace the plugs if the cables are removed.
• Connect a network cable to any management port.
• Connect one or more of the fiber capture network ports to the network that you want to capture
traffic from. All ports are 1 Gbps capable, and depending on your unit, Ports 1 and 2 are also 10 Gbps capable.
• If you need external time synchronization, plug the supplied PTP time synchronization cable into
the connector.
• Connect the power cords to the redundant power supply in the ThreatEye
The ThreatEye Network Traffic Recorder unit is now connected and ready for initial configuration.
TM
Network Traffic Recorder unit and install it in a rack or similar. See the product
Network Traffic Recorder unit is powered off.
TM
INSTALLATION QUICK START
Flex 4x1/10 Gbps
Network Traffic Recorder unit.
TM
Network Traffic Recorder unit.
TM