NETGEAR GA302T Reference Manual page 46

Table 6-1. Refer to the following table for help to configure optional adapter properties.
Properties: Description:
802.1p QOS The 802.1p Quality of service (QOS) is an OSI layer 2 standard for prioritizing
network traffic at the data link sublayer.Tag is recognized by 802.1p aware
switches and routers.
Checksum Offload Supports hardware offload of checksum in the transmit and receive directions.
When enabled, this option allows the card to verify the TCP/IP checksum of incoming
(Rx) and/or outgoing (Tx) packets. This improves the TCP/IP transmit/receive per
formance by offloading this operation from the CPU.
Speed & Duplex A performance option that allows you to choose how the card transmits and receive
packets over the network.
Moving the Network Card to a Different Slot
Windows 98 automatically detects the installation and removal of hardware.To move
a GA302T Copper Gigabit Adapter to a different slot in the same system:
1. Shut down the system and remove the card from the PCI slot.
2. Install the card in its new PCI slot (see "Installing Your Copper Gigabit Adapter"
on page 2-7).
3. When the system is powered on, reinstall the driver software (see "Installing the
Driver Software" on page 3-1).
Windows 98 software 6-6