ATON Dla2Rf Quick Installation Manual

Start Here

Run all speaker wiring (16 gauge is recommended) to the DLA2RF.
Be sure to label the wires for easy identification.
Place the DLA2RF in the same equipment location as the Receiver/Amplifier.
Turn off all power to the Receiver/Amplifier and make sure the DLA2RF power supply is unplugged!
Strip approximately 3/8" of insulation from the ends of all speaker wiring.
Twist the exposed end of each speaker wire to ensure that no loose strands remain.
1
Choose Receiver/Amplifier Type
A
Stereo Receiver with "A/B"
To local speakers To DLA input
Connect
to the "B"
– –
speaker
terminals.
L
R
Speaker Wire
B
Home Theater Receiver with "A/B"
To local speakers To DLA input
Connect
to the "B"
– –
speaker
terminals.
L R
Speaker Wire
C
Home Theater Receiver with "Zone 2"
To DLA input
Connect
to the
–
"Zone 2"
speaker
L
terminals.
Speaker Wire
NOTE: Refer to your receiver manual for help
activating your "Zone 2" speaker outputs.
4
5 Turn on the Receiver/
Plug in the DLA2RF
Amplifier and start
Power Supply.
audio source (CD
player, radio, etc.).
Power
Audio Source
9 Turn on one room 10 While listening to the room turned
from the front panel
on in the previous step, slowly adjust
of the DLA2RF and the Receiver/Amplifier volume to
adjust volume level a level that is the loudest it can
to maximum. play in the room without distortion
or clipping. Make a note of the
volume level for future reference.
+
–
–
+
+
–
–
+
–
R
+
–
–
+
6 Adjust the Receiver/ Receiver/ 7
Amplifier
volume
to the
lowest level. el.
Start Receiver/Amplifier
Volume Knob
11
Finally, turn on each room
ust
from the front panel of the
DLA2RF and adjust to a
comfortable listening level.
Receiver/Amplifier
Volume Knob
Speaker Wire
WARNING! Do not connect speakers to the DLA2RF that have an impedance value lower than what is supported
by your receiver/amplifier. In doing so, you run the risk of overheating and damaging both the DLA2RF and your
receiver/amplifier! Consult speaker and receiver/amplifier manuals for their specific impedance ratings.
2

Connect Speakers

– –
+ +
Be sure to connect the positive speaker wire to the
positive input of the speaker and the negative speaker
wire to the negative input of the speaker.
3

Connect RF Receiver

Connect the RF Receiver
to the ATON Port
Set the Receiver/
8

If using a Receiver with "A/B" speaker outputs:

Amplifier to stereo
mode and disable
the speakers connected to the DLA
any surround
sound or DSP
NOTE: When using the "A+B" setting, the receiver volume will need to be adjusted accordingly.
"Sound Fields."
When the DLA2RF is not in use, turn off the "B" speakers and turn on
!
the "A" speakers for normal stereo/surround sound listening.
Please consult your owner's manual for additional
installation examples, applications and safety instructions.
3/8"
– –
+ +
RJ11
OR
both the "A" speakers and those
connected to the DLA