Page 2
Installation and maintenance must be performed by qualified Power consumption: ≤ 0.5W technical personnel only. ▪ DP600/630/650 must be used only in the manner outlined in this Max. wire diameter for power supply and output signal: 1.5 mm² instruction manual. ▪...
Page 3
0222 DP600/630/650 / Instruction Manual • Approvals DP600 and DP630 can be mounted on the container either from the side or vertically from top or bottom. DP650 is for top mounting only. Dust Ex • For side mounting it is recommended to screw the unit into the...
Page 4
DP600/630/650 / Instruction Manual 0222 Wiring This model must be connected to a supply and analysing unit as follows: T1: 20-30vDC T2: ground Safety Guidelines: ▪ The instruments must be used only at fixed installation of the cables Note: 2-Wire version is NOT ATEX or UKEX approved.
Page 5
Maintenance Contact the distributor who has supplied you with this instrument for spare parts or contact Hycontrol directly. DP600/630/650 require no maintenance. For applications with materials that tend to be sticky we recommend Assembling of probe, enclosure and electronics must be done according cleaning the vibrating rod of the instrument periodically.
Page 7
Marking of approved instruments according to ATEX directive 2014/34/EU or UKEX SI 2016 No. 1107 (as amended): On the enclosure of the vibrating level switches DP600StEx / DP630StEx / DP650StEx is a nameplate showing the following data: e.g: DP600 StEx with wide range power supply, standard unit (no high temp) e.g:...
Page 8
DP600/630/650 / Instruction Manual 0222 Protection according to EN 60079-0 and EN60079-31: • protection by dust-tight enclosure IP6X • limited surface temperatures of the apparatus Maximum surface temperatures: Zone Type Max. permissible Max. surface Heat up *The 35K maximum heat up of...
Need help?
Do you have a question about the DP600 and is the answer not in the manual?
Questions and answers