Advertisement
Quick Links
FORM 143PL INSTRUCTIONS FOR MOUNTING POWER FEED
SYSTEM ON LT15DC SAWMILLS REV.D1.00
To mount the power feed system (Part No. 500730) on LT15DC Rev. D1.00 sawmills with manual
feed system, manufactured from 1 October 2009 it is necessary to:
1. Remove the lower guard.
Form 143PL Instructions for mounting power feed system on LT15DC sawmills Rev.D1.00doc012810
WARNING!
Before performing any service to the sawmill control
box panel, turn the key to the "0" position.
Page 1
Advertisement
Related Manuals for Form 143PL
Summary of Contents for Form 143PL
- Page 1 To mount the power feed system (Part No. 500730) on LT15DC Rev. D1.00 sawmills with manual feed system, manufactured from 1 October 2009 it is necessary to: 1. Remove the lower guard. Form 143PL Instructions for mounting power feed system on LT15DC sawmills Rev.D1.00doc012810 Page 1...
- Page 2 2. Remove the middle track cover with a felt strip. 3. Remove the rope as well as the front and rear rope mount brackets. Page 2 doc012810Form 143PL Instructions for mounting power feed system...
- Page 3 4. Remove the feed crank and the manual feed system bracket. 5. Remove the rope guide roller system. Form 143PL Instructions for mounting power feed system on LT15DC sawmills Rev.D1.00doc012810 Page 3...
- Page 4 6. Dismount the control box front panel. Mount the forward/backward joystick and the feed rate potentiometer. Make electrical connections according to the electrical diagram located at the end of these instructions. Page 4 doc012810Form 143PL Instructions for mounting power feed system...
- Page 5 (1) and bolt the tensioners (3) to the end pins. Fasten the spring to the short tensioner. 8. Mount the motoreducer with four bolts. Form 143PL Instructions for mounting power feed system on LT15DC sawmills Rev.D1.00doc012810 Page 5...
- Page 6 10. Mount the cable. Install it on the pulley as shown below and secure with clamps (1). Tighten the rope until the gap between the spring coils is .8-1.2 mm. 0,8-1,2mm Page 6 doc012810Form 143PL Instructions for mounting power feed system...
- Page 7 11. Mount the new middle track cover with a felt strip. Soak the felt strip with oil (WD-40). 12. Mount the motoreducer pulley front cover. Form 143PL Instructions for mounting power feed system on LT15DC sawmills Rev.D1.00doc012810 Page 7...
- Page 8 13. Mount the new lower guard. 14. Make electrical connections according to the electrical diagrams. Page 8 doc012810Form 143PL Instructions for mounting power feed system...
- Page 9 LT15G15 Electrical Diagram with Power Feed System Form 143PL Instructions for mounting power feed system on LT15DC sawmills Rev.D1.00doc012810 Page 9...
- Page 10 LT15D10 Electrical Diagram with Power Feed System Page 10 doc012810Form 143PL Instructions for mounting power feed system...
Need help?
Do you have a question about the 143PL and is the answer not in the manual?
Questions and answers