Table of Contents
Advertisement
If you come into range of the paired device with the Ear Muffs switched on, a Bluetooth®
connection will automatically be established .
You may need to approve the connection on the communication device .
Please refer to the instructions for use of the communication device on this topic!
If you leave the range of your communication device with your Ear Muffs, the LED indicator
will flash blue and white . If the connection is not restored within 5 minutes, the Bluetooth®
4
paring mode will switch off .
The Ear Muffs may be manually switched off by holding the
seconds until the acoustic signal sounds and the LED indicator
˜ Connecting the Ear Muffs to a second Bluetooth
The Ear Muffs may be connected to two Bluetooth
the Ear Muffs are already connected to a device, follow the steps below to connect to the second
device:
Activate multipoint mode by pressing and holding the
acoustic signal will then sound . The first communication device (mobile phone or computer) is
then disconnected .
Now connect to the second communication device via Bluetooth® with the Ear Muffs . Please
refer to the notes in the instructions for your communication device . Select the entry "PKB 5 A1"
from the list of devices detected by your computer or mobile . The second communication device
is then connected .
Briefly press the
button
is then reconnected again . Now, both communication devices are connected to the Ear Muffs
simultaneously .
˜ Clearing paired devices
In paired mode (the LED indicator
3
hold the
button
The Ear Muffs are now in pairing mode . The LED indicator
Press and hold
button
The memory in the Ear Muffs is now cleared . After clearing the paired memory, the Ear Muffs
will no longer automatically connect to the device you used before and you will need to
manually pair to the device again .
˜ Putting on the Ear Muffs
The Ear Muffs can be adjusted to your head size and the speakers with earpads
the headband with a rail for this purpose . Adjust these to ensure optimal comfort .
Please note the marking "L" (= left) and "R" (= right) on the inside of the headband immediately
above the speakers with earpads
right .
˜ Conversations function (level-dependent attenuation)
After power on, the Ear Muffs will automatically turn on the conversations function to listen to
the surrounding sound . If the surrounding sound is too loud and up to hazardous levels the Ear
Muffs will mute for the users protection until all has quietened down .
3
and the acoustic signal will sound . The first communication device
4
will briefly flash blue twice every 5 seconds), press and
for 3 seconds and the acoustic signal will sound .
3
for approx . 3 seconds and two beeps sound .
9
. Put on the Ear Muffs so that the control buttons are on the
On/Off button
4
goes out .
communication devices at the same time . If
®
3
button
for approx . 3 seconds . The
4
will flash blue and white .
5
for 3
device
®
9
are secured to
US-EN
15
Advertisement
Table of Contents
