IMPORTANT READ ME FIRST
1. The delay time between buttons is within 6
seconds. If there is no input within 6 seconds,
the remote will exit the current setting
procedure
2. The motor will jog and beep as a hint. Continue
programming after the hint.
1 Pairing
Apply power to motor (1 jog and
long beep once), within 7s,
press STOP for 2s (2 jogs and 3
beeps), the motor has been
paired successfully
2 Switching Rotating Direction (Optional)
If the UP button is pressed, but the
screen goes down, you will need to
complete this step
Press and hold the UP and DOWN buttons
simultaneously for 2s, motor will jog once
and rotation will be switched successfully
*The motor needs to be in the reversing operation
without limits
Motorized Screen
Remote Instructions
DC2700 Remote – Single Channel
3 Setting Upper and Lower Limits
UPPER LIMIT
Move the screen up to the desired upper
limit
LOWER LIMIT
Move the screen down to the desired
lower limit
4 Adjusting Limits
Adjust Upper Limit
Adjusting Lower Limit
Press and hold UP + STOP
simultaneously for 2s (2
jogs, 3 beeps) upper limit
is set
Press and hold DOWN +
STOP simultaneously for
2s (2 jogs, 3 beeps) Lower
limit is set
Press and hold UP + STOP
simultaneously for 5s (1
jog, 1 Long beep) Repeat
step 3
Press and hold DOWN +
STOP simultaneously for
5s (1 jog, 1 Long beep)
Repeat step 3
Need help?
Do you have a question about the DC2700 and is the answer not in the manual?
Questions and answers
I just purchased two Dooya DC2700AC remote controls and I'm trying to pair each one with their corresponding Dooya DT52E-45 curtain motor. But nothing seems to work. Please help.
Where is plug inserted on screen to charge a motor, model DOOYA DC 2702DC
The remote was working and now is not operating What needs to be done
If the Dooya DC2700 remote is not operating, the following troubleshooting steps can be taken:
1. Check power and connections – Ensure the motor has power and the wiring is correct.
2. Replace remote battery – A low battery can cause no response.
3. Check RF interference – Ensure there are no other RF sources causing interference and verify the motor antenna.
4. Move remote closer – The remote may be out of range; move it closer to the unit.
5. Verify installation – If the motor starts slow or makes loud noise, check that the installation is correct.
This answer is automatically generated
THE REMOTE CONTROL HAVE BATTERIES AND HOW TO DO IT
The Dooya DC2700 remote control is battery-operated, but the provided context does not include instructions on how to replace the batteries.
This answer is automatically generated
translation to dutch
HOW TO CHANGE BATTARI