Kramer EXT3-POE-XR-R Quick Start Manual

Scan for full manual
Step 1: Check what's in the box
EXT3-POE-XR-R 4K HDMI/USB Receiver
1 Power adapter and cord
Step 2: Get to know your EXT3-POE-XR-R
# Feature
1 HOST USB B 2.0 Connector
2 ACTIVE HOST LED
3 IN LED
4 OUT LED
5 LINK LED
PoE► LED
6
7 ON LED
HDBT IN PoE◄►
8
9 HDMI OUT
10 USB A 2.0 Charging Connector 1
11 USB A 2.0 Charging Connectors
2-3
12
13 IR 3.5mm Mini Jack Connector
14 RS-232 3-pin Terminal Block
15 1G LAN RJ-45 Connector
16 SETUP 4-way DIP-switch
17 48V DC
EXT3-POE-XR-R Quick Start
EXT3-POE-XR-R Quick Start Guide
This guide helps you install and use your
Go to www.kramerav.com/downloads/EXT3-POE-XR-R
firmware upgrades are available.
Function
When the device DIP-switch is set to active host as defined in
and outputs, connect a USB host (for example, a room PC) to communicate with the
USB peripheral devices (for example, a smart board) connected to USB device ports
on this device or the connected remote device.
Note that an active host can be set only one device, either the transmitter or the
receiver, not both.
Lights orange when the USB host side is active.
Lights blue when an active HDMI input signal is detected on HDMI IN.
Lights blue when an output acceptor device is connected.
Lights green when the HDBT active link connection is established.
Lights green when power-providing over HDBT is active.
Lights green when the device receives power.
Connect to the HDBT connector on a paired PoE-accepting transmitter device (for
example, a
Connect to an HDMI acceptor.
Connect to the USB local peripheral devices (for example, a USB PTZ camera). When
the USB Host PC is disconnected, the USB signal and charging power for this port
are inactive.
Connect to the USB local peripheral devices (for example, a USB camera, a
soundbar, a microphone and so on). When the USB Host PC is disconnected, the
USB charging power for this port continues to be active.
Bidirectional IR connection. Outputs a received IR signal (from the HDBT transmitter)
to connected IR emitter or transmits an IR signal (from IR sensor) to the HDBT
transmitter.
Bidirectional RS-232 connection. Outputs a signal received from a controller device
(for example,
the remotely connected PTZ USB camera).
Connect to LAN for Ethernet extension to the transmitter.
Sets the device behavior (see
Connect to the power supply.
EXT3-POE-XR-R
to download the latest user manual and check if
1 Bracket set
4 Rubber feet
EXT3-C-XR-T device).
SL-240C
) to control a remote device via serial connection (for example,
Step 4:Connect inputs and
P/N: 2 9 0 0 - 3 0 1 5 6 3 QS
for the first time.
1 Quick start guide
Step 4:Connect inputs
outputs).
Rev: 1