1. Manuals
  2. Brands
  3. RAK Manuals
  4. Camera Accessories
  5. RAK9155
  6. Quick start manual

RAK RAK9155 Quick Start Manual

Battery plus system
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Documentation Center
RAK9155 Quick Start Guide
Overview
Safety Instructions
This manual contains important instructions and warnings that must be followed during the installation and
maintenance of the RAK Battery Plus system.
RAK9155 installation and service require knowledge of DC electricity and should only be performed by certified
installers (either locally or by RAKwireless). RAKwireless assumes no liability for injury or property damage due to
repairs attempted by unqualified individuals or a failure to properly follow the instructions provided.
Used Symbols
These symbols indicate important safety information in this guide or on the equipment:
Documentation
WARNING - Indicates a hazardous situation that if not avoided, could result in injury.
⚠
CAUTION - Indicates a hazardous situation that, if not avoided, could result in minor injury or damage to the
equipment.
NOTE - Indicates an important step or tip that leads to the best results, but is not safety or damage-related.
Equipment
REFER TO THE OPERATING INSTRUCTIONS: Indicates that the user should refer to
operating or installation instructions before proceeding.
RISK OF ELECTRIC SHOCK: Indicates components that present a risk of electrical shock.
DISCHARGE: Discharge time is 5 minutes from de-energization.
BIDIRECTIONAL TERMINAL: Indicates the location of the combined input/output
connector on the equipment.
PROTECTIVE CONDUCTOR TERMINAL: Indicates the location of the grounding connection on
the equipment.
CAUTION, RISK OF ELECTRIC SHOCK, ENERGY STORAGE TIMED

Advertisement

Table of Contents
loading

Summary of Contents for RAK RAK9155

  • Page 1 RAK Battery Plus system. RAK9155 installation and service require knowledge of DC electricity and should only be performed by certified installers (either locally or by RAKwireless). RAKwireless assumes no liability for injury or property damage due to repairs attempted by unqualified individuals or a failure to properly follow the instructions provided.

  • Page 2: General Warnings And Cautions

    Do not install RAK9155 near heat sources. If there is a chance for the ambient temperature to reach 55 ℃ or higher, make sure to shield RAK9155 from direct sunlight either by placing the device under the solar panel or other type of shield.

  • Page 3: Safety Precautions

    Documentation Center Safety Precautions RAK9155 is designed with full consideration for safety. However, all electrical appliances can be dangerous if used inappropriately; it can cause a fire or electric shock that leads to severe injury. For your protection, please read these safety precautions thoroughly.
  • Page 4 Documentation Center  CAUTION If you ignore any of the following instructions, it can cause injury or damage to nearby products. Prohibitions Do not cover the vent. If the vent is covered, heat may build up inside the set and cause an accident. 1.

  • Page 5: Precautions For Use

    Documentation Center Disposal with specified method Contact technical vendor when you discard. Do not disassemble, destroy, or dispose of in fire. WARNING ⚠ If liquid is leaking from the product, observe the following measures. Do not allow the liquid to come in contact with skin or clothing. 1.
  • Page 6 Documentation Center Parameter Value Cell Type LiFePO4 (LFP) Rated Voltage (V) 12.8 Rated Capacity (Ah) Rated Energy (Wh) Usable Battery Capacity (Ah) Usable Battery Energy(Wh) Battery Depth of Discharge 100% Battery Max Charge/Discharge Power(W) 128/128 Configuration 1P4S Working Voltage Range (V) 10.0～14.6 Standard Charge Current (A) Max.

  • Page 7: Installation

    Documentation Center Parameter Value Voltage Difference in each module (mV) ≤20 IP Rating IP65 Recommended Usage (indoor/outdoor) Outdoor Net Weight (kg) ~8 kg Dimension (L/W/H, mm) 499x280x75（±3) mm Interfaces Figure 1: Right-Rear View of L051100-A Item Name Model Remarks LP-16- C02PE-02- IP67, 2pins, Pin1-Positive;...

  • Page 8: Pre-Installation Preparation

    Documentation Center Pre-Installation Preparation The equipment is heavy, please ensure personal safety when carrying it. During installation, please ensure the installer complies with all the necessary safety regulations to ensure personal safety. Do not place equipment and mounting kit on pedestrian walkways to avoid accidental damage to equipment. Carry the Equipment You can carry the equipment with both hands.
  • Page 9 Documentation Center 2. Install two M6 screws on the back of the equipment, leave a gap of about 3 mm. 3. Connect the Cables to the circular connectors. The other terminal of 2pin cables (PV INPUT1 and PV INPUT2) are connected to the PV panel outputs. Figure 4: Install screws and connect cables NOTE The cables should be connected before installing equipment on the pole, otherwise it is difficult to do it.

  • Page 10: Power On And Off

    Power Switch button. Turn on the Power Switch even though the green LED is blinking. If RAK9155 does not connect to either the load or the solar panel, the green LED would be off in 2 minutes.
  • Page 11 Documentation Center It should be stored in 60% SOC status. It should be stored in a well-ventilated environment, Temp. < 35 °C, ROH <65%. It should be stored avoiding humid conditions. It should be stored in a place where it can be monitored by a professional. Disclaimer It should be noted that RAKwireless shall not be liable if any necessary materials are added to this user’s manual without further informing the already existing customers.

Table of Contents