Page 2
PRECAUTIONS Thank you for purchasing the FC‐P2. We sincerely hope that it will bring convenience and enjoyment to your daily life. Please read the instructions before using the chair in order to operate and maintain it properly. FC‐P2 assumes no responsible for personal injury or property damage sustained by or through the use of this product. Please pay attention to the followings content with these warning symbols. Failure to take precautions could result in serious injuries. It can also damage or decrease the life expectancy of the FC‐P2. ...
Safety Guide The user must be with sound mind and judgment. They must be conscious and have unimpaired motor functions in their hand to use the controller. The user must read this user’s guide before operating the chair and get familiar with its components and features.
Page 6
Safety Guide (continued) Driving on bends Lightly push the joystick in the direction of the bend. Practice speed control. Practice avoiding obstacles Lightly push the joystick in either directions to avoid and maneuver around the obstacle/s, practice speed control. Driving Fast Push the joystick all the way in the direction you want to go. Pull the joy‐ Stick back to the middle if you do not feel you are 100% in control. Driving over small curbs ...
Page 7
Safety Guide (continued) Entering &Exiting Elevator The user should pay attention to the opening and closing intervals of the elevator door to avoid collisions while entering or exiting the elevator. Driving on sidewalks The user should stay on the sidewalk and avoid entering the motor vehicle lane unless to cross the street. Pay attention to obstacles and avoid contact with them. Crossing the street Pay attention to avoid cars and only cross when you are allowed. Must drive slowly over the curb, to get back on the sidewalk, which should not be more than 3cm high. ...
Page 8
Safety Guide (continued) Driving over a high curb/step or steep incline. Driving over too high of a curb/ step (more than 3 cm) could result in rollover. Driving on a very steep incline could also result in a rollover. Getting into and out of a bed/chair/couches We recommend that the user has assistance getting out and into the chair. Move the armrests and footrest out of the way before entering and exiting the chair. Driving downhill ...
Page 9
Safety Guide (continued) Driving through the crosswalk Make sure your chair has sufficient power before crossing the crosswalk. Stopping suddenly because of power loss in the middle of the street can cause personal injury or even death. Self repair of the FC‐P2 DO NOT attempt to repair the product on your own .It may cause permanent damage to the chair and could put yourself at risk of injury or death. The product should be repaired by a professional repair shop or maintenance service personnel. ...
Page 10
Safety Guide (continued) Washing the FC‐P2 DO NOT hose down(Spray) the chair with water or any liquids. It will cause damage to the chair and could also harm or endanger your personal safety. Wipe with a cloth. ...
Instructions 1 Installation (1).Put the both sides of the handrail outward, press down strongly on both sides of the seat cushion until the seat cushion flattened. (2). Unfold the handle you hear the buzz, check whether there exists shaking or not. (3.) Install the leg support 8 ...
Page 12
Instructions (4).Expand the pedal down (5). Install the battery, connect the battery power cord. (6). Install the controller Note: Do not hand grasp the cushion on both sides of the frame tube, to prevent the fingers were pressed. 2 Folding (1).Turn off the power (2.) Fold up the foot pedal upwards 9 ...
Page 13
Instructions (3).Pull up from the middle of the cushion (4).Open the folding mechanism of the card, the push hand down. 3 Other functions (1). Pull the foot bracket switch. After rotating outward, lift up and remove the foot tray. 10 ...
Page 14
Instructions (2) . Pull the anti‐tipping switch, you can adjust the height up and down. (3).The rotary switch adjusts the front and back distances of the controller. (4).Adjust the foot pedal height. (Note: Please ensure that the foot pedal from the ground height of 50mm or more) 11 ...
Page 15
Instructions (5). Press up and down the red rod to switch between electric and manual mode. Electric Manual 12 ...
Page 16
Instructions 4 Instruction of FC‐P2 wheelchair APP (1) .Users can choose the corresponding two‐dimensional code according to the mobile phone system. Wheelchair APP (for Android) Wheelchair APP (for ISO) (2) After downloading, firstly, turn on the Bluetooth function of the mobile phone, then turn on the wheelchair power button and App, select the corresponding Bluetooth serial number of the wheelchair, and enter the user interface. (3) Users can read the detailed information of the wheelchair through the operation of APP, such as the left and right wheel speed, gradient, electricity, remaining mileage, etc. The parameters of wheelchair can also be set by APP, such as setting gear, setting steering sensitivity and setting driving sensitivity. Bluetooth remote control can also be used to control the movement of wheelchair. 13 ...
Page 17
Instructions (4)Characteristics of FC‐P2 power system Temperature detection, when the controller temperature is too high (55 1 degrees), it will automatically alarm. Intelligent detection of road conditions: A. road surface gradient is higher than 9 degrees, will automatically alarm, remind caution driving; 2 B. downhill automatically limits speed and speed. C. when the turning speed is too large and there is danger, it will automatically alarm. D. the motor will be turned off when there are serious accidents such as rollover. 3 Over current detection, current limiting 4 Over voltage protection, low voltage alarm App has many functions: A. set turn sensitivity and driving sensitivity according to users' individual needs. 5 B. has Bluetooth remote control function. C. Bluetooth remote switch machine. D. can be upgraded online. Manufacturer app can configure production information by itself, such as motor 6 size, front and rear drive, current limiting, gear speed and so on. 7 5 speed adjustable The self‐checking function of the boot hardware is abundant, so that the 8 hardware is stable and reliable. 9 It has voice function and rich voice information. 10 Power saving, long journey duration 11 The ramp stops and does not slide. 14 ...
Page 18
Instructions (5)APP interface for electric wheelchair: 15 ...
Batteries and chargers 1 safe use and maintenance of the battery This product has two batteries, place them under the electric wheelchair, do not need to move. (1) Incorrect replacement The battery may be at risk of explosion. Replace the battery, you can only use the same or the manufacturer recommended the same type of battery, and should pay attention to the battery polarity should be correct. (2). The point to extend the battery life: regular charge(twice a week) even if you do not use the chair 2 Charger requirements Charger for the electric wheelchair internal power supply charge to use when charging, in the electric wheelchair when charging this product can not be used. 3 Specifications of charger Input voltage :AC 220V Output voltage:24V/DC Output current:2.8A 4 Charging steps The charger provides charging for the electric wheelchair, the main plug is connected to the power supply, and the other charging connector is connected to the lower slot of the controller. Please follow the below instructions to complete the charging procedures: 17 ...
Page 21
Batteries and chargers (1). Check that the electrical slot under the controller is not blocked. (2). Make sure the power switch of wheelchair is off. (3). Plug the output plug of the charger into the slot under the wheelchair controller. (4). Plug the main plug on the charger into the power area, the red power light will light up, the charging process takes about 2 to 4 hours (5). When the charging green light is on, it indicates that the battery has been charged. (6). Turn off the switch on the charger and unplug the output plug from the wheelchair. 5 Maintenance of the charge (1). We recommend that you use the charge as a daily routine; If you do not use the battery pack for a long time, please remove the battery case from the wheelchair and check it 3‐4 times a month. (2). If the battery is charged for more than 16 hours and is not fully charged, it indicates that the charger may have a problem or the battery is aging. If the above problems occur, do not repair it yourself. This may cause danger, please contact the supplier or customer service immediately, as soon as possible to replace the battery to avoid damage Attention: Please do not expose the charger to the outdoor heat source, such as radiator, fire, sunshine. ●Do not move the wheelchair until the battery charger plug and the power main plug are 18 ...
Page 22
Batteries and chargers unplugged from the wheelchair and power supply. Do not turn on the controller's switch when charging. ●After Charging completes, the charging indicator light turns to "green light", do not stop charging before charging is complete. ●After charging, remove the charger plug, but the longest charging time can not exceed 24 hours, there will be overcharge of the danger. ●Charging time relates to the outside temperature, in the winter needs a longer charging time. ●Observe the following rules to avoid danger when charging: 1) Please use the standard charger of our company. Non‐standard charger is easy to lead to danger, and strictly prohibited in addition to the charging line to change or modify, if the resulting product or personnel accident, the company is not responsible for it. 2) Do not disassemble or modify the charger. 3) When charging, it should maintain good ventilation, not exposed to sunlight and humid environment charge. 4) Do not cover any tarpaulins or items when charging. 5) When the charger works, there will be a fan sound, please rest assured that the use of this function for the cooling effect, but the charger shell will be slightly elevated temperature to normal conditions. 6) The charger has no waterproof function. 7) Do not charge the charger above the flammable items, such as oil, foot pedal or seat. 19 ...
Trouble Shooting Problem Reason Solution Controller host power is not Connect host power Power won’t turn on connected Connect four core plug with joystick Controller host and joystick are not connected ...
Technical Specification Width when Width when Dimension of Dimension of Width of seat unfold fold up rear front (mm) wheel(inch) wheel(inch) (mm) (mm) 24" (22"optional 8" ) Distance between leg Height of the Height of Loading Net support and seat armrest Weight(Kg) the ground (Kg) (mm) (mm) (mm) 29.5 Height of the Distance Height Length ...
Packing list Name Quantity Electric Wheelchair Leg Support Seat Cushion Back Cushion Belt for Leg Support Controller Lithium Battery Instruction Certificate Wrench 22 ...
Service History Date Description of Service Warranty Part Coverage Remarks Frame 2Years Non-deliberate damage Motor 1Years Non-deliberate damage Battery 1Years Non-deliberate damage...