Table of Contents
Advertisement
Use
Connecting the power cable
1. Make sure that the ON/OFF switch
is in the OFF position (0).
2. Make a loop with the extension cable
and guide this through the opening of
19
the strain relief
3. Guide the loop over the hook of the
strain relief.
4. Slowly tighten the loop against the
strain relief.
If you do not tighten the cable, it may
become loose during work and fall out.
5. Plug the power plug of the leaf vacuum
into the socket of the extension cable.
6. Plug the power plug of the extension cable into a properly installed outlet.
Assuming the work position
1. Put on the carrying strap
chest and back.
Adjust the length of the carrying strap so that the bottom vacuum tube
be moved close to the ground.
2. Hold the handle of the motor housing
10
with the other hand.
Vacuuming/blowing leaves
1. Make sure that the device is completely assembled and connected.
2. Set the operating mode.
3. Set the speed.
You can adjust the speed during operation.
4. Switch the device on.
Vacuuming: hold the leaf vacuum in front of you and push it over the ground
with the guide rollers.
Blowing: walk slowly and swing the blow tube left and right with controlled
motions, approx. 10 cm above the ground.
5. Switch the device off and disconnect it from the mains.
24
17
.
11
so that it lies across your shoulder and crosses your
1
A
with one hand and the extra handle
19
3
can
Advertisement
Table of Contents
