Monster Electric 4 Frame Instruction Manual page 5

USER GUIDE
ASSEMBLY INSTRUCTIONS
1. Start by attaching the three legs to the main body of the honey extractor, using the nuts
and bolts provided.
2. Attach the honey outlet valve to the main body, using one of the provided nuts and
bolts.
3. For extra stability, bolt the legs of the honey extractor into the ground.
4. Before starting the electric honey shaker, check whether the voltage and frequency are
consistent with the operating voltage and frequency parameters.
5. After the extractor is turned on and the indicator light is on, adjust the speed dial from
low speed to high speed to test the extractor before first use.
USER GUIDE
OPERATING INSTRUCTIONS
1. With the control dial set to "0" and power switch set to off (O), plug the power cord into
the wall outlet.
2. Use the bee brush provided to gently brush away any bees that may be stuck to the
honey frames.
3. Place your honey frames in the extractor basket, 4 at a time. If the extractor is loaded
with less honey frames, ensure that there are at least 2 frames opposing each other to
keep the extractor balanced as this will reduce any possible shaking.
4. Close both lids.
5. Flip the power switch on, and turn the dial until the basket is spinning at the desired
speed. Turn the dial back to "0" when frames have been emptied.
6. Once the frames have been emptied on one side, remove the frames, turn them around,
and place them back in the extractor. Repeat previous steps, then remove the frames
from the extractor.
7. With the valve positioned over a bucket or similar container, open the honey outlet valve
to drain the honey from the extractor.
28105 - ELECTRIC 4 FRAME HONEY EXTRACTOR
05