One-Pedal Driving - GMC HUMMER EV 2023 Owner's Manual

To use this feature:
1. Ensure the vehicle is in D (Drive).
2. From the center position, move the shift
lever back.
After releasing the shift lever, it will
return to the center position
To exit L (Low) and shift into D (Drive) or
N (Neutral): At any speed, shift to D (Drive)
or N (Neutral).
To exit L (Low) and shift into P (Park) or
R (Reverse):
1. Bring the vehicle to a complete stop.
2. Shift to the desired gear.
Cruise control can be used while the vehicle
is in L (Low) Mode.

One-Pedal Driving

One-Pedal Driving allows the use of the
accelerator pedal to control the deceleration
of the vehicle to a complete stop.
Completely releasing the accelerator pedal
will result in aggressive deceleration.
Partially lifting off the accelerator pedal
allows the deceleration of the vehicle to be
adjusted as desired.
Use the brake pedal if emergency braking is
required.
To view and configure One-Pedal Driving,
from the infotainment display home screen,
select Settings, then Vehicle, and then
One-Pedal Driving.
Select Off to disable One-Pedal Driving for
traditional two-pedal driving, similar to a
gasoline vehicle.
Select On to enable One-Pedal Driving where
a moderate level of braking is applied when
the accelerator pedal is released while
driving.
Select High to enable One-Pedal Driving
where a strong level of braking is applied
when the accelerator pedal is released while
driving.
When enabled, One-Pedal Driving applies in
D (Drive) and L (Low). The vehicle will remain
in One-Pedal Driving mode, including
through vehicle off and on power cycles,
Driving and Operating
until manually disabled by the driver. Press
the accelerator pedal to the desired speed.
The brake lamps will come on during
substantial deceleration and when the
vehicle is stopped.
If One-Pedal Driving is turned off while
stopped, the vehicle will stay stopped. Press
the brake pedal or accelerator pedal to
return to two-pedal driving.
For faster access, One-Pedal Driving can be
toggled on the Driver Mode screen. Turn the
driver mode knob to bring up the driver
mode screen.
l
Touch to toggle One-Pedal Driving on or
off. When turned on, One-Pedal Driving
returns to the previously selected level. To
change the level, press the Settings link in
the pop-up box to go to the full One-Pedal
Driving selection.
187