Advertisement
7. Install the volume control in the box or ring using the two longer
screws provided. Be careful not to force the volume control into
the ring or box as this will cause the connectors to become
loose or may result in wires being forced out of the connectors.
8. Place Decora plate over volume control. Insert and tighten short
color-matched screws until the cover is tight and flush with the wall.
DO NOT CONNECT THE WIRES FROM THE AMPLIFIER TO THE
VOLUME CONTROL UNTIL YOU HAVE CHECKED THE FOLLOWING:
• Measure the resistance between the + and – of each pair of
wires that is to be connected to the amplifier's speakers outputs
using an Ohm Meter. Under no circumstances should this value
be below 3.5 Ohms. A reading of less than 3.5 Ohms may mean
that the wiring input and output connectors on the volume
control have been reversed. An open reading likely indicates a
polarity reversal.
• Confirm that the amplifier is powered down before connecting
any volume control wires to it.
6
Advertisement
