Summary of Contents for Grouser Products JD 9030 Series
- Page 1 JD 9030 Series Joystick Installation Instructions Purchase Date Serial Number Model Number Tractor Model Dealer PN: 63-17752-3 Date: 2-16-2018...
-
Page 2: Bolt Torque Specifications
Index Description Page Bolt Torque Specifications Inventory Bracket and Joystick Installation Valve Bracket Installation Valve Installation Plumbing Cable Installation Valve Cover Installation Joystick Operation Joystick and Hydraulic Schematic 9-11 Warranty Bolt Torque Specifications Bolt Thread Grade 5 Grade 8 Bolt Grade 8.8 Grade 10.9 Dia. - Page 3 Inventory QTY. PN Description 16-11436 10-24 x 1" Socket Head Cap Screw 16-20005 1/4" X 1 1/4" Hex Bolt Gr 5 NC 16-20006 1/4" X 1-1/2" Hex Bolt Gr 5 NC 16-20034 5/16" x 1" Hex Bolt Gr 5 NC 16-20558 1"...
- Page 4 Bracket & Joystick Installation NOTE: Your machine may vary slightly from the machine in this manual, but the same installation procedure will be compatible. NOTE: The following pictures show the joystick assembly already in place. The joystick will be installed in a later step. 1.
-
Page 5: Valve Installation
Valve Installation 7. Attach the control valve (1) to the valve mount with 4 - 5/16” x 1” bolts and 4 - 5/16” flat washers (B). Plumbing 8. If fittings are not installed in the LS port on the control valve, install a straight -6-5 fitting (PN: 31-34033) and a 90°... - Page 6 NOTE: Steps # 14-16 were originally for a JD 9000 series tractor. Picture may be different than your tractor but you still need disconnect the LS hose or line and install the shuttle valve. See diagram below. 14. Disconnect the LS hose or line at the rear of the NOTE: Oil will flow.
-
Page 7: Cable Installation
NOTE: Valve shown from the bottom and may look slightly different. Start with the Lift hoses next to the hoses that were connected to the Tractor R and P ports. 17. Guide the dozer lift hoses to the rear of the tractor. -
Page 8: Valve Cover Installation
27. Guide the 3 cables and Dins from the wire harness out to the rear of the tractor. Put the supplied rubber seal on each Din connector. 29. Connect the Lift, Tilt, and Angle Dins to the corresponding connections on the back of the control valve. - Page 9 Joystick Schematic...
- Page 10 Joystick Schematic...
-
Page 11: Hydraulic Schematic
Hydraulic Schematic... - Page 12 Warranty Grouser Products warrants to the original purchaser of each item that the product be free from defects in material and workmanship under normal use and service for a period of two (2) years for Agriculture Series Blades and one (1) year for Heavy Duty Series from date of original retail delivery.
Need help?
Do you have a question about the JD 9030 Series and is the answer not in the manual?
Questions and answers