Summary of Contents for 2bfirst Cadillock Alarm
- Page 1 Alarm The ultimate anti-theft device The ultimate anti-theft device www.cadillock.com www.2bfirst.com...
- Page 2 Installation and operating instructions Installations- und Bedienungsanleitung...
- Page 3 PLEASE PAY ATTENTION TO THE SAFETY GUIDELINES EMPHASIZED IN RED. THEY ARE INTENDED FOR YOUR SAFETY. Cadillock Alarm is a product of 2bfirst technologies gmbh ® Cadillock is a registered trademark of 2bfirst technologies gmbh ®...
-
Page 4: Table Of Contents
Dear customer, thank you for buying the Cadillock Alarm and for your trust in our ® product. Please read these operating instructions carefully, since they contain important information about the installation and usage of the device and, above all, also serve to keep you safe. Also please pay particular attention to the explanations of the enclosed safety screw and the enclosed Allen wrench (installation instructions step 3) as well as the recommen-... -
Page 5: Functional Description
Scope of delivery: • Cadillock Alarm main device with positive cable (red, 35 cm), ® U clip ground cable (black) and connection cable (pink) for the alarm siren (including transparent plastic insulation sleeve) • alarm siren (118 dB, 20 W) with power connection cable (includ- ing transparent plastic insulation sleeve), ground cable (black) and 2 mounting screws •... -
Page 6: Installation Of The Cadillock Alarm
The alarm system monitors the interior, doors, bonnet and boot. It has the following equipment features: • Shock sensor (individually adjustable) • Voltage sensor (individually adjustable) • Panic alarm / vehicle finder function • Pre-warning function • Mute setting mode •... -
Page 7: Preparation
Preparation: Selection of the installation point Switch off the engine and open the bonnet (or any other access to the car battery). Make sure that the ignition has been switched off along with all electricity consumers. If the car battery has a cover, open it and then follow the installa- tion instructions. -
Page 8: Step 1: Removing The Negative Cable
The removal of the negative cable can lead to data loss in electrical devices (radio, CD player, board computer, etc.). This data loss can be prevented by using a data back-up device. For this purpose, 2bfirst technologies offers the Memo-Guard (www.memo-guard.com). Step 2: Attaching the positive cable to the Cadillock Alarm ®... -
Page 9: Step 4: Attaching The Negative Cable Again
Cadillock Alarm. For this purpose, 2bfirst technologies, as ® a licensing partner of ADAC, offers the ADAC-Battwatch (www.battwatch.com). -
Page 10: Step 5: Installing The Alarm Siren
Step 5: Installing the alarm siren • Attach the alarm siren with the help of the two enclosed screws at a suitable point on a random metal part of the vehicle; in this process, attach the black ground cable of the siren between the screw head and the metal holder of the siren. -
Page 11: Registration Information / Customer Card
The installation of the Cadillock Alarm is completed. Now the ® Cadillock Alarm is ready to use and protects your vehicle. ® C. Registration information / customer card PLEASE OBSERVE: Your customer card is included in the scope of delivery. The device number of your Cadillock Alarm is noted on this card. - Page 12 shock sensor are activated. During the next 15 minutes, the Cadillock Alarm checks whether all electricity consumers have been ® deactivated, then there is one more confirmation tone as an indicator that the voltage sensor has now been activated as well. If any electricity consumers are activated in the vehicle even after 15 minutes, the function of the voltage sensor remains deactivated.
- Page 13 Panic alarm function / vehicle finder alarm Press the button to deter potential thieves or to find the vehicle. The alarm signal will sound for 30 seconds without interruption; as soon as you press the button again, the alarm signal is switched off.
- Page 14 navigation systems that also receive messages when the ignition is switched off. In individual cases, this may result in an activation of the voltage sensor and therefore the Cadillock Alarm and this may ® lead to the alarm being sounded. In this case the voltage sensor should be set to the lowest sensitivity level.
-
Page 15: Replacing The Battery Of The Remote Control
NOTE: Additional wireless remote controls can be ordered from the manu- facturer at www.2bfirst.com. Your correct registration is a require- ment for this. The device number on your customer card has the code of your personal wireless remote control. -
Page 16: Disassembling The Cadillock Alarm
F. Disassembling the Cadillock Alarm ® Step 1 First please remove the negative cable of your vehicle from the neg- ative pole of the car battery and release the negative U clip connec- tion cable of the Cadillock Alarm from the screw connection. ®... -
Page 17: Guarantee
G. Guarantee The guarantee of the Cadillock Alarm is valid in case of defects and ® malfunctions for 24 months starting with the date of purchase. However, the guarantee does not apply to malfunctions from dam- ages caused by an accident, improper use, or a damage that was the result of a non-compliance with the installation and operating instructions. -
Page 18: Technical Data
H. Technical data Case - SGS-certified, fireproof fibre-glass/ nylon material by DUPONT - water- and dust-resistant according to IP65 (International Protection Ratings) - dimensions: L: 139 mm x W: 110 mm x H: 30 mm Operational voltage 12V nominal voltage Operational temperature The resistance of the internal compo- nents is designed for –... - Page 19 2 mm PC (polycarbonate), fireproof connection (UL-compliant material) Red cable 4 AWG; max. temperature 105 °C Certificates CE, E24, FCC, RoHS, ECE-R 116 EC Declaration of confor- see PDF under “Cadillock Alarm, mity according to R&TTE Technical Data“ on the cadillock.com Directive 99/5/EC website.
- Page 20 Cadillock Alarm is a product of 2bfirst technologies gmbh. ® Cadillock is a registered trademark of 2bfirst technologies gmbh. ® Am Alten B • D-77694 Kehl 78 51 – 0 – – 8 99 99 – – 29 – •...