Postal Pro PP3400 Installation Instructions

READ ENTIRE INSTRUCTION SHEET BEFORE
BEGINNING PROJECT
PARTS LIST
Mailbox
Body
Mailbox
Door
U S
M A I L
Mailbox
Door Knob
(2) Mailbox
Pins
HARDWARE
Shown at actual size
A
(4) #10 – 24 x 1-1/2" Phillips
Machine Bolts
B
(4) #10 – 24 Nuts
C
(8) #12 x 1" Self Tap Screws
NOTE: Customers are required to contact
the local post office before installing the mailbox
to ensure its correct placement and height at the street. Generally,
mailboxes are installed at the height of 41–45 inches from the road
surface to inside floor of mailbox or point of mail entry (locked designs)
and are set back 6–8 inches from front face of curb or road edge to the
mailbox door.
* PLEASE NOTE: Concrete may be needed if installing in loose soil
Mailbox
Mounting
Bracket
Post
Sleeve
Installation Instructions
The Craftsman Mailbox and Post Kit
RECOMMENDED TOOLS & SUPPLIES
• POST HOLE DIGGER
• POST LEVEL OR STANDARD LEVEL
• PHILIPS HEAD POWER SCREWDRIVER
• HAMMER / RUBBER MALLET
• PRESSURE TREATED 4" x 4" x 50-62" WOODEN POST*
(Not Included) 50" Minimum height. Actual Diameter of a Standard 4" x 4"
Pressure Treated Post: 3-1/2" x 3-1/2"
WARNING: "Call Before You Dig" – Dial 811.
811 is the designated "call before you dig" phone number that directly
connects you to your local One Call center. Each state has different
rules and regulations governing digging to insure that buried utility
lines will not be disturbed.
STEP 1 Determine location for mailbox. Using post hole digger, dig a hole
24" in depth. Install treated pine post by burying 24" of the post in the
ground - leaving at least 26" of post above ground. The 4x4 post can be up
to 38" above ground, but only 26" is necessary. Use level to ensure treated
pine post is in correct vertical position. Stabilize the treated pine post by
firmly tamping down loose soil around post base.
Model: PP3400
38"
Maximum
26"
Minimum
50"– 62"
24"