1 Composition Bill validator Recyclers set Chassis Stacker 1. Front of the validator 2. Switches of the validator 3. Led status of the validator 4. Front connector 5. Switches of the recyclers 6. Led status of the recyclers 7. Recyclers extraction button 8.
2 Operational use In CashDro3 the bills are stored in the recycler by means of a stacking system. The recyclers module consists of 2 recyclers of different denominations, which by default will be 5 € and 10 €. This method minimizes jams and increases dispensing speed.
3 Status led Status led of the Device status validator Blue Activated Front off Stand by Green Incidence Status led of the Device status recyclers Green Initializing Stand by Error during firmware updating Status led | 3...
4 Connections The Bill Device has 3 connectors on the back of the chassis with the connected cables which power and communicate Bill Device with the MiniPC and the Power Supply. Connections | 4...
5 Test To verify the proper operating state of Bill Device the following checks must be carried out: • Check that the assembly of Bill Validator, Bill Recycler and Stacker is correct and there is not any element with mobility •...
6 Maintenance manual 6.1 Supplies The tools required for maintenance are: • Can of compressed air • Alcohol‐free LCD cleaner • Anti‐static microfiber cloth • A set of cotton swabs • A pair of gloves • Cleaning card for Bill Validator Maintenance manual | 6...
The cleaning process of Bill Device must be realized with CashDro3 on and in the charge screen. You must insert the cleaning card when the front of the validator is in blue, that is to say, active.
The cleaning card will be discarded when mostly are black or dry. During the process is possible that the validator is not active in blue. Wait several seconds until the cessation of moisture in the validator, restart CashDro and continue the operation.
Page 11
Due the cleaning card clean exclusively the validator, you need to review the indicated sensors and review that not are dirty or obstructed. Type of sensor Type of sensor a RC2 End sensor LED k RC2 Full sensor LED b RC1 End sensor LED l Lifter Home position Sensor LED c Recycle Unit Sensor m Lifter Home position Sensor PT...
6.3 Interval The following table is a guideline for the periods when maintenance should be employed based on the average number of bills inserted into the unit per day (24h): Bill per Day (BPD) Interval ≤ 325 3 Months ≤ 500 2 Months ≤...
Need help?
Do you have a question about the CashDro3 and is the answer not in the manual?
Questions and answers