Advertisement
Read this first!
WARNING
Do not remove any screws other than those indicated when
„
replacing the lamp unit.
If this is not observed, electric shocks, burns or other injuries may occur.
Do not disassemble the lamp unit.
„
If the lamp breaks, it could cause injury.
Lamp replacement
„
The lamp has high internal pressure. If improperly handled, an explosion and severe
injury or accidents will result.
z The lamp can easily explode if struck against hard objects or dropped.
z Before replacing the lamp, be sure to disconnect the power plug from the wall outlet. Electric
shocks or explosions can result if this is not done.
z When replacing the lamp, turn the power off and allow it to cool for at least 1 hour before
handling it otherwise it can cause burns.
CAUTION
Do not use the old lamp unit.
„
If used it could cause lamp explosion.
If the lamp has broken, ventilate the room immediately.
„
Do not touch or bring your face close to the broken pieces.
Failure to observe this will cause the user to absorb the gas which was released
when the lamp broke and which contains nearly the same amount of mercury as
fluorescent lamps, and the broken pieces will cause injury.
z If you believe that you have absorbed the gas or that the gas has got into your eyes or mouth,
seek medical advice immediately.
z Ask your dealer about replacing the lamp unit and check the inside of the projector.
Notice (for USA only)
Hg-LAMP CONTAINS MERCURY, Manage in Accord with Disposal Laws.
See: www.lamprecycle.org or 1-888-411-1996.
This lamp is used in projectors.
It is not intended to be used for indoor lighting of ordinary homes.
Illustrations in this manual
Illustrations contained in this manual that show the projector may differ from the
z
actual objects they depict.
2 - ENGLISH
Always follow these precautions
2009 / 125 / EC
Advertisement
