Troubleshooting
Normal Operating Sounds
picked up and thrown against the condenser on rainy
days or when the humidity is high. This design feature
helps remove moisture and improve efficiency.
compressor cycles on and off.
or on rainy days. The water may overflow and drip
from the outdoor side of the unit.
check and see that the rubber Subbase Water Plug is
properly inserted. This plug may be removed during
operation to minimize water in the back of the unit;
however, removing it will lower the efficiency of your
unit.
Keeping Unit Installed in Winter
the indoor side of your unit may become cold to the
touch when the weather gets cold outside.
commercially available outdoor covers are sold and will
help mitigate these issues.
49-5000634 Rev. 4
coils can make a pinging noise. This helps cool the
condenser. You can reduce this noise by opening the
water hole seal located on the lower right side of the
unit. Opening this seal will lower the Energy Efficiency
of your unit.
NOTE: Do not drill hole in the base pan.
Subbase Water Plug
17
Need help?
Do you have a question about the ClearView AHTT06BC and is the answer not in the manual?
Questions and answers
Turn off blinking filter - where is the filter pad to touch to turn off?
The Filter Reset pad on the GE AHTT06BC is located on the unit’s control panel. Pressing this pad after cleaning and reinstalling the filters will turn off the blinking filter indicator light.
This answer is automatically generated