UCTB-27 User’s Manual Table of Contents FOREWORD ............................4 1.1 C ..........................4 OPYRIGHT OTICE 1.2 N ..............................4 OTES 1.3 S ............................. 4 TATEMENT 1.4 D ............................5 ISCLAIMER 1.5 L ................... 5 IMITATION OF IABILITY WARRANTY 1.6 S ..........................
Vantron reserves all rights of this manual, including the right to change the content, form, product features, and specifications contained herein at any time without prior notice. The latest version of this manual is at www.vantrontech.com.cn.
1.5 Limitation of Liability/Non-warranty For direct or indirect damage to this device or other devices of Vantron caused by failure of conforming to this manual or the safety instructions on device label, Vantron assumes neither warranty nor legal liability even if the device is still under warranty.
Page 6
Clean with a damp cloth. Do not try cleaning exposed electronic components unless with a dust collector. Support for special fault: Power off and contact technical support personnel of Vantron in case of the following faults: The device is damaged.
UCTB-27 User’s Manual Over View 2.1 Introduction Thank you for choosing Vantron. It is our commitment to provide our valued customers with the embedded devices equipped with the state-of-the-art technology and the best product services. Tablet enables the interaction between operators/users and applications, connects industrial control products such as wireless, transducer, battery inside, storage, etc.
UCTB-27 User’s Manual 2.2 Features Specifications Processor RK3288W, CPU: Quad-core Cortex-A17, up to 1.6GHz GPU: Mali-T764, up to 500MHz 2GB DDR3-1866 ( Optional 4GB ) Memory Flash 32GB eMMC 5.1 ( Optional 8GB or 16GB ) Storage 1xMicro SD ( Internal )
Page 9
UCTB-27 User’s Manual Order Part Example UCTB-27 RK3288W ARM -core, Cortex-A17 1.6GHz Quad WIFI 802.11 a/b/g/n/ac, BT 5.0. CPA-G44-UWT4 Note: please contact Vantorn for other order information. www.vantrontech.com.cn...
UCTB-27 User’s Manual Hardware Description This chapter describes the hardware Features, include switch, jumper, connector and PIN function. The interface description ought to consult the connector sketch map. And attach necessary message such as picture. Indicate the figure, PIN1 and match jack.
UCTB-27 User’s Manual This button used for power on/off the display plane. This status is power off. 4.1.2 AC Jack This port plug in a AC100V~240V cable. 4.1.3 Recovery button This button function is for update. While push the recovery button and power on the display plane, it will work at recovery mode.
In the aim of avoiding accidents as far as possible, it is not allowed to replace the system or change components unless with permission and certification. Please contact the technical department of Vantron or local branches for help. Pay attention to caution signs.
Page 16
Vantron assumes no responsibility of possible missing contents and information, errors in contents, citations, examples, and source programs. Vantron reserves the right to make necessary changes to this manual without prior notice. No part of this manual may be reprinted or publicly released in forms of photocopy, tape, broadcast, e-document, etc.
Page 17
(2) this device must accept any interference received, including interference that may cause undesired operation. Any modification to the product is not permitted unless authorized by Vantron. It’s not allowed to disassemble the product, it is not allowed to replace the system or change components unless with permission and certification.