1. Manuals
  2. Brands
  3. Nady Audio Manuals
  4. Stereo System
  5. RPA-4
  6. Owner's manual

Nady Audio RPA-4 Owner's Manual

4 channel portable sound system
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
OWNER'S MANUAL
RPA-4
4 CHANNEL PORTABLE SOUND SYSTEM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RPA-4 and is the answer not in the manual?

Questions and answers

Summary of Contents for Nady Audio RPA-4

  • Page 1 OWNER’S MANUAL RPA-4 4 CHANNEL PORTABLE SOUND SYSTEM...

  • Page 2: Table Of Contents

    This unit was developed using the expertise of professional sound engineers and working musicians. You will find that your new NADY AUDIO RPA-4 has superior performance and greater flexibility than any other portable sound systems in its price range. Please read this manual carefully to get the most out of your new unit.

  • Page 3: Warning

    ATTENTION RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR IMPORTANT SAFETY INSTRUCTIONS When using this electronic device, basic precautions should always be taken, including the following: Read all instructions before using the product. Do not use this product near water (e.g., near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming pool, etc.).

  • Page 4: Installation

    (Note: Nady Systems is not responsible for shipping damage. If the unit is damaged, do not return to us, but notify your dealer and the shipping company immediately to make a claim.

  • Page 5: Front Panel Controls & Connections

    FRONT PANEL CONTROLS & CONNECTIONS (11) (12) (13) FRONT PANEL Note: 1 through 6 below are referenced to Channel 1. The other 3 channels are identical. (1) GAIN CONTROL The Gain Control determines the proportion of the channel signal in the mix, (2) REVERB CONTROL The Reverb Control adjusts the level of signal sent by each channel to the internal Reverb DSP (Digital Sound Processor).

  • Page 6: Rear Panel Controls & Connections

    (20) EXTERNAL SPEAKER OUTPUT 1/4" (6.3mm) jack for connecting an external speaker cabinet to the RPA-6. The connected speaker impedance must be 8 ohms or greater. The RPA-6 external speaker output delivers 50W RMS of power @ 8 Ohms.

  • Page 7: Specifications

    SPECIFICATIONS AMPLIFIER AND SPEAKER Power ...100W RMS @ 4 Ω S/N Ratio ... >115dB THD Power output, 20Hz to 20KHz ... <0.1% Speaker ...8 Ω Tweeter type ...Compression Dome Woofer ... 10" FREQUENCY RESPONSE (Mic input to output) Line level o/p @ +4dBu into 600 Ω ...20Hz- 20KHz ±3dB Power amp o/p 1 watt into 8 Ω...
  • Page 8 SERVICE FOR YOUR NADY AUDIO PRODUCT (U.S.) Should your NADY AUDIO product require service, please contact the Nady Service Department via telephone at (510) 652-2411, or e-mail at service@nady.com. (International) For service, please contact the NADY AUDIO distributor in your country through the dealer from whom you purchased this product.

Table of Contents