Table of Contents
Advertisement
DANGER!
• Your product is heavy. Remove packaging
reinforcement as displayed in the figure.
• Be careful not to get your hand caught
under the machine during this procedure.
3.3 Removing the transit bolts
A
PRECAUTION!
• Do not remove the transit bolts before
removing the packaging reinforcement.
• Remove the transit bolts before operating
the washing machine! Otherwise, the
product will get damaged.
C
INFORMATION
• Keep the transit bolts in a safe place to
reuse when the product needs to be
moved again in the future.
• Never move the product without the transit
bolts properly fixed in place!
11 / EN
1
1 Use a tool to
loosen all bolts until
they rotate freely.
2
2 Remove the transit
bolts by turning
them slightly.
3
3 Attach the plastic
covers supplied in
the user manual
bag into the holes
on the rear panel.
3.4 Connecting water supply
C
INFORMATION
• It is necessary to have 10 – 80 liters of
water flowing from the fully open tap in one
minute to have your product run smoothly.
Attach a pressure reducing valve if water
pressure is higher.
C
INFORMATION
• It is also recommended to attach a
pressure reducing valve if you experience
overflow from the detergent dispenser
during water fill between 3.5 to 10 bars
(0.35 to 1 MPa).
A
2
CAUTION!
• Models with a single water inlet should not
be connected to the hot water tap. In such
a case the laundry will get damaged or the
product will switch to protection mode and
will not operate.
3
1
A
CAUTION!
• Ensure that the cold water connection is
made correctly when installing the product.
Otherwise, your laundry will come out hot
at the end of the washing process and
wear out.
1
3
2
1 Connect the special
hose supplied
with the product
to the water inlet
on the product.
2
2 Tighten the hose
nuts securely
by hand. Never
use a tool when
tightening the nuts.
Washer-Dryer / User Manual
3
Advertisement
Table of Contents
