Page 1
www.hilltop-products.co.uk - Tel: +44 1942 723101 - Email: sales@hilltop-products.co.uk Original instruction KD-51Easycut Hot Wire Foam Cutter Operating instruction ● Please read this instruction carefully before operation ● Take special care on safety prompts in these instructions so as to avoid injury to yourself, other people and objects.
Page 2
Original instruction Introduction The KD-51 Hot Wire Cutter is a professional-grade hot cutting machine for foamed plastics. The KD-51 Hot Wire Cutter heats up in seconds and gives the Button switch. Recommended Use Expanded Polystyrene (EPS), Extruded Polystyrene (XPS), can be easily cut with cutting procedures.
Page 3
Original instruction Plug In Frame Spring Vertical degree (0º -75º ) Shapes to be cut Rectangle 1.Setting the Vertical Degree at 0º. 2.Setting the Guider Ruler at 0º . 3.Cutting according to the scale of the ruler. Ladder-shaped Triangle 1.Setting the Vertical Degree at 0º. 2.Setting the Guider Ruler at needed degree 3.Cutting according to the scale of the ruler.
Page 4
Original instruction ─ Consider work area environment ─ Do not expose tools to rain. ─ Do not use tools in damp or wet locations ─ Keep work area well lit. ─ Do not use tools in the presence of flammable liquids or gases ─...