OttLite GX7867 Quick Start Manual

B
E
4

Craft Organizer Tray

194374
INS140106
D
C
A
5
5
1
1
1
1
2 3
6
Clamp with Universal Adapter
on round pole
ENglIsh
1. The following items should be included in the package.
(A) Tray
(B) Clamp (with wingnut and bolt)
(C) Universal Adaptor (only use with round poles)
(D) Pincushion
(E) Utensil holder
2. Press the Utensil holder (E) into the tray as shown in
Figure 1 of the diagram.
3. To attach the Clamp (B) onto the lamp pole, remove the
2
wingnut and bolt.
2
2
4. Spread the Clamp (B) just enough to fit over the pole as
shown in Figure 2.
5. Insert the bolt into the Clamp (B) from the same side it
was removed as shown in Figure 3.
6. Thread the wingnut onto the bolt and move the Clamp (B)
into position then tighten firmly by hand. DO NOT attach
it to the flexible neck or overtighten wingnut as this may
damage it.
7. Slide the Tray (A) onto the pole above the clamp, ref.
Figure 4.
8. Secure the Tray (A) by pressing it into the clamp, ref.
Figure 5.
If the lamp pole is round:
Attach the clamp onto the pole without completely
tightening the wingnut and bolt. Place the Universal
adapter (C) onto the pole above the Clamp (B) and
slide down into the Clamp, ref. Figure 6. Make sure the
Universal Adapter's recessed side is positioned upward as
shown in Figure 6. Tighten wingnut and bolt firmly by hand
and proceed with steps 7 and 8 to complete assembly.
CAUTION: The maximum loading on the tray is 1 lb.
Overloading the tray may cause the tray to detach
from the clip.
GX7867
Craft Organizer Tray
3
3
REV040714
KAKA
3