Advertisement
Read this first!
WARNING:
■ Before replacing the lamp unit, be sure to turn the power off and to
disconnect the power plug from the wall outlet.
z Electric shocks or explosions can result if this is not done.
■ Do not disassemble the lamp unit.
z If the lamp breaks, it could cause injury.
■ Do not remove unspecified screws during the lamp unit replacement.
z Doing so can cause electric shocks, burns, or injury.
■ Do not touch the fan with your fingers or any other parts of your body
when replacing the lamp unit.
z Doing so can cause injury.
■ When replacing the lamp unit, turn the power off and allow the lamp to
cool for at least one hour before handling it.
z Failure to observe this will cause burns.
■ Be careful to hold the lamp unit cover and to loosen the lamp unit cover fixing
screws with the projector installed upward in the vertical direction since the
lamp unit cover may open and the lamp case may drop off on its weight.
z This can cause severe injury or accidents.
■ When you loosen or fix the lamp case fixing screws with the projector
installed upward in the vertical direction, make sure to hold the lamp
case handle since the lamp case may drop off on its weight.
z This can cause severe injury or accidents.
NOTICE
For USA only
Hg-LAMP CONTAINS MERCURY, Manage in Accord with Disposal Laws.
See: www.lamprecycle.org or 1-888-411-1996
Before replacing the unit
z Make sure to turn off the power before replacing the
unit.
z When switching off the projector, make sure
to follow the procedures in "Switching off the
projector" (
page 3).
■ Checking the lamp unit to be
replaced
Check the status of the lamp
indicators <LAMP1>/<LAMP2>/<LAMP
3>/<LAMP4>.
z The lamp unit corresponding to the lamp indicator
that is lit in red is required to be replaced.
2-ENGLISH
Always follow these precautions
■ Notes on the replacement of the
lamp unit
z A Phillips screwdriver is necessary when
replacing the lamp unit.
z Since the luminous lamp is made of glass, it may
burst if dropped or hit with a hard object. Please
handle with care.
z Do not disassemble or modify the lamp unit.
z When replacing the lamp unit, be sure to hold it
by the handle because its surface is pointed and
its shape is protruded.
z The lamp may be burst. Replace the lamp
unit carefully so that the broken pieces of the
lamp glass will not scatter. When the projector
is mounted on the ceiling, do not make the
replacement directly under the lamp unit or put
your face near it.
Advertisement
