Advertisement
Quick Links
Date Purchased:
Date Installed:
Serial Number:
Local Representative:
For assistance please call your local representative or call (386)453-5091
www.flowmarkwater.com
FlowMark Model Mark-II-SC
Installation Operation Manual
EPA Est.#: 92852-FL-1
Record Information About Your System
sales@flowmarkwater.com
flowmark
flowmark
flowmark
flowmark
(386) 453-5091
Advertisement
Summary of Contents for FLOWMARK Mark-II-SC
- Page 1 FlowMark Model Mark-II-SC Installation Operation Manual EPA Est.#: 92852-FL-1 Record Information About Your System Date Purchased: Date Installed: Serial Number: Local Representative: For assistance please call your local representative or call (386)453-5091 www.flowmarkwater.com sales@flowmarkwater.com (386) 453-5091...
- Page 2 7. Warranty Card Power Requirement All FlowMark Systems are fitted with a auto-switching power supply that can accept 110VAC or 220 VAC power input. Systems are supplied with a molded 110 VAC Power Cord that can be plugged in to any 110 VAC wall outlet. If you choose to run the unit on...
-
Page 3: Electronic Controller
The treatment pads can be installed on horizontal or vertical piping. Two treatment pads are included with this model FlowMark system. The dimensions of the pads are too large to use an opposing install on 2” pipe but may be installed opposing each other on 3”... - Page 4 Installing the Pipe Cover: The white PVC pipe cover with the FlowMark label is included to provide a finished look to the installation. 1. Hold the pipe cover up to the area where the treatment pads have been installed and mark the pipe where the ends will be.
- Page 5 Be sure to neatly route the signal cable between the Controller and the Treatment Pads to avoid damage. Plug the FlowMark Controller into a 110 VAC outlet and observe the yellow and blue lights. YELLOW LIGHT ON = Power to the Controller BLUE LIGHT ON Treatment Active.