Table of Contents
Advertisement
Problem
Possible Cause
No power/
Washer is unplugged
washer not
working or
dead
Water supply is turned off
Circuit breaker/fuse is
tripped/blown
Automatic self system
checks
Snags, holes,
Overloaded
tears, rips or
excessive wear
Pens, pencils, nails, screws
or other objects left in
pockets
Pins, snaps, hooks, sharp
buttons, belt buckles,
zippers and sharp objects
left in pockets
Control time
This is normal
wrong or
changes
Not enough
This is normal
water
Washer
Pump clogged
pauses or
has to be
restarted, or
washer door is
locked and will
not open
What To Do
• Make sure cord is plugged
securely into a working
outlet.
• Turn cold faucet fully on.
• Check house circuit
breaker/fuses. Replace
fuses or reset breaker.
Washer should have
separate outlet.
• First time the washer is
plugged in, automatic
checks occur. It may take
up to 2 minutes before
you can use your washer.
This is normal operation.
• The dry weight of the load
should be less than 18 lbs.
• Remove loose items from
pockets.
• Fasten snaps, hooks,
buttons and zippers.
• During spin the washer
may need to rebalance
the load sometimes
to reduce vibrations.
When this happens,the
estimated time is
increased causing time
left to increase or jump.
• Horizontal washers do
not require the tub to fill
with water like top-load
washers.
• See page 25 on how to
clean the Pump Filter.
31
Advertisement
Table of Contents
