Momentum MDSMOMBAR15 Mounting Instructions

Please follow these installation and care instructions
to ensure that your product is attached safely and that
it retains its high quality finish. This instruction guide
applies to the following:
MDSMOMBAR15 — Grab 'n' Grip 15 inch Straight Grab Bar
Please ensure that suitable attachment hardware is
used and compatible with wall construction materials.
Attachment hardware is not provided with these
grab bars!
Tools required
Pencil, Drill, Masonry Drill*, Ceramic Drill Bit*, Level,
Phillips Screwdriver
*Drill bits must be suited to the wall type and attachment
method. Keep tools out of the reach of children
Home Safety Advice
• Always be careful when using power tools, particularly
in the bathroom.
• Always check for hidden cables and pipework before
drilling and take extreme care if there is any water
in the working area.
• Always wear suitable eye protection when drilling.
• If the product is to be attached on a ceramic tile wall,
a ceramic drill bit should be used.
• Always ensure that the drill hole passes through the
tiled rather than through the grouted.
• To prevent damage to the tile, mask the area around
the hole with tape before drilling.
• Do not strike the product with hard or sharp objects.
Product Location
• The grab bars are only as strong as the wall to which
they are attached and the attachment hardware used.
• For different wall types you will need to ensure that
you are using the correct attachment hardware.
• The addition of backboards on the outside of the wall
or appropriate strengthening of internal structures
may be required to provide adequate wall strength.
Grab 'n' Grip –
Grab Bar
Mounting Instructions
NOTE: If the wall is made of lightweight thermal blocks,
aerated hollow brickwork or prefabricated partitions,
even the most appropriate hardware may not be able
to withstand the loads which can be suddenly applied
to grab bars.
MDSMOMBAR15