Table of Contents
Advertisement
Quick Links
T6
ANALOG MULTIBAND RF MODULE
Installation and
Operating Instructions
TiL Document No. 22RE638
Revision B
OCTOBER 2022
Technisonic Industries Limited
240 Traders Boulevard, Mississauga, Ontario L4Z 1W7
Tel: (905) 890-2113 Fax: (905) 890-5338
www.til.ca
Copyright by Technisonic Industries Limited. All rights reserved.
Advertisement
Table of Contents
Related Manuals for TIL T6
Summary of Contents for TIL T6
- Page 1 ANALOG MULTIBAND RF MODULE Installation and Operating Instructions TiL Document No. 22RE638 Revision B OCTOBER 2022 Technisonic Industries Limited 240 Traders Boulevard, Mississauga, Ontario L4Z 1W7 Tel: (905) 890-2113 Fax: (905) 890-5338 www.til.ca Copyright by Technisonic Industries Limited. All rights reserved.
- Page 2 Changes or modifications not expressly approved by Technisonic Industries could void the user’s authority to operate the equipment. This manual is designed to provide information about the T6 Multiband transceiver module. Every effort has been made to make this manual as complete and accurate as possible.
-
Page 3: Table Of Contents
FRONT PANEL PROGRAMMING ................. 4 INSTALLATION INSTRUCTIONS B GENERAL ........................6 INSTALL INTERFACE BOARD ..................6 INSTALL MODULE ......................7 ALIGNMENT AND TEST ....................7 SPECIFICATIONS B SPECIFICATIONS ......................8 T6 Multiband Transceiver Module Operating Instructions TiL 22RE638 Revision A... -
Page 4: Introduction
225 to 400 MHz Military Aeronautical Communications The T6 module has no physical user interface. All control of the module is performed through a serial RS232 interface. The operating instructions in section 2 assume an installation in a Technisonic TDFM-9100 transceiver. -
Page 5: General
An LED display, a keypad, and a rotary knob provide the operator control of RF modules installed in the unit. The T6 module will always be band 3. The display shows the activity of the selected module as well as the soft key menu of the active band. The active module is selected by pressing the BAND key. -
Page 6: Knob
The T6 module on band 3 will always have the following menu items: Selecting PWR will allow the power output of the radio to be set to high or low. -
Page 7: Display
2.11 FRONT PANEL PROGRAMMING Band 3 (T6) is an analog multiband module that covers the following bands: 30 – 50 MHz FM 108 – 118 MHz AM receive only (navigational VORs, ILS, etc) 118 – 138 MHz AM (aviation band) 225 –... - Page 8 91.5 131.8 192.8 94.8 136.5 203.5 TABLE 1: TDFM-9100 CTCSS/PL/TPL Tones vs Motorola PL Codes The following is a list of TDFM-9100 supported DCS/DPL CODES: TABLE 2: TDFM-9100 DCS/DPL Codes T6 Multiband Transceiver Module Operating Instructions TiL 22RE638 Revision A...
-
Page 9: General
The others are very similar. The T6 is intended to be mounted in the TDFM 9300/9200 or 9100 chassis and is not visible. Therefore, a second label must be applied to the outside of the of the TDFM-9X00 that contains the following text: For TDFM-9300 “TDFM 9300 Multiband, “Contains Module: FCC ID IMA-T6”... -
Page 10: Install Interface Board
TECHNISONIC INDUSTRIES LIMITED INSTALL INTERFACE BOARD The interface board is only required in the TDFM-9100 Transceiver. Remove top cover and install interface board assembly 203085. Install 6 screws with lock washers. T6 Multiband Transceiver Module Operating Instructions TiL 22RE638 Revision A... -
Page 11: Install Module
Connect the antenna coax as shown above. Install new top cover #218212. FINAL ALIGNMENT AND TEST Perform final alignment procedure for appropriate transceiver model. Perform final test procedure for appropriate transceiver model. T6 Multiband Transceiver Module Operating Instructions TiL 22RE638 Revision A... -
Page 12: Specifications B
< 5% Intermodulation in dB: > 65 > 65 > 65 Adjacent Channel Rejection in dB: 25 kHz Channel spacing > 65 > 65 >65 8.33 kHz Channel spacing > 60 T6 Multiband Transceiver Module Operating Instructions TiL 22RE638 Revision A...
Need help?
Do you have a question about the T6 and is the answer not in the manual?
Questions and answers