CFH CFHSO0200 Installation Manual

CFHSO0200
Heavy Duty 20-Amp 2400-Watt Appliance Surge Protector
⚡
Smart Plug Kit with outlet saver power cord.

Contents:

• One protector in a plastic blister pack.
• 1- foot power extension cord (optional).

Preparation:

• If required, pull the appliance away from the wall, or enclosure,
to access its power outlet. Leave out for at least 1 hour to test.
• If there is another device plugged into the same outlet, use the
extension cord to plug it in after the protector install.
• It is a good idea to test the wall outlet is grounded and is wired
correctly using a "outlet tester".

Configuration:

• Using a flat screwdriver, set the lower voltage threshold level on
the back of the plug. We recommend setting it to 95V.

Install:

• Make sure the black power switch is in the off position (0) on the
front of the protector.
• Plug your appliance into the protector socket and then insert the
protector into the wall outlet.
• Turn on the protector switch (1).

LED status check:

• The
stable voltage is detected and the normal
• If the
lights are displayed for over 10 minutes, then read the
Troubleshooting guide over the page.
• Run the appliance for 1-2 hours and check the LED status is ok.

Post Install:

• If required, use the 1-foot power cord to plug in any secondary
device into a double or triple outlet. It is preferable that only the
protector is plugged into the wall outlet and nothing else.
1.1
cleverfamilyhomes.com/power-protection
- Installation Guide
yellow waiting light may display for 3 minutes before a
yellow waiting light, or the over/under
support@cleverfamilyhomes.com
green light comes on.
red lights, or no