Related Manuals for Classic Coffee Concepts MRC3AF
Summary of Contents for Classic Coffee Concepts MRC3AF
- Page 1 Classic coffee concepts INSTALLATION,OPERATION,AND SERVICE MANUAL FOR MRC3AF AUTOMATIC BREWER WTTH HOT WATER FAUCET Model MRC3AF 23.43Wx8.43Dx20.87H 1750W,14.58A Ship Wt approx.26.46LB’s Decanters Not Included...
-
Page 2: Installation Instructions
PLUMBER ’S INSTALLATION LN STRUCTIONS CAUTION: Power to brewer must be OFF before proceeding with plumbin g installation 1) Attach flow/strainer assembly to back of brewer. Strainer inlet will point down. 2) Flush water line before installing brewer. Brewer should be connected to COLD WATER LLNE for best oper ation 3) Water pressure should be at least 20 lbs For less than a 25 ft run ,use 1/4’... -
Page 3: Warranty
WARRANTY Classic Coffee Concepts coffee bre wers are watt anted a gainst defects in workmanship or materials, under normal use, for 90 Days from the date of purchase Brewer parts are warranted against defect for 12 months from date of purchase. -
Page 4: Troubleshooting Guide
TROUBLE SHOOTING GUIDE TROUBLE SHOOTING GUIDE POSSIBLE CAUSE SYMPTOM WATH TO CHECK REMEDY IRRECULARYIELD 1.Not siphoning properly 1.Refer to "DRIPPING",Step1. 1..Refer to "DRIPPING",Step1. 2.Timer 2..Timer consistency,Time 2. If times are irregular ,replace 3.Fluctuating water pressure several brew cycles timer 4.Solenoid valve 3. - Page 5 COLDWARMER 1.Warner-defective 1.Voltage at warmer terminals 1.If voltage is present on STATION 2.Warmer ON/OFF Switch should be 120volts AC terminals,but warmer will not 3.Bad baroness 2.If voltage is not present on beat ,replace warmer warmer terminals,check 2.If switch does not make and continuity of switch .
-
Page 6: No Hot Water
TROUBLE SHOOTING GUIDE SYMPTOM POSSIBLE CAUSE WHAT TO CHECK REMEDY CAN' T START 1.No water 1.Incoming water line&water 1.Be sure water shut off is open. BREW CYCLE 2.NO power shut off 2.Replace or rest circuit protector 3.ON/OFF switch 2.Fuse or circuit breaker 3.If ON/OFF switch does not 4.Brew star switch Power cord and plug... - Page 7 DRIPPING 1.Not siphoning propertly 1.Water should flow freely 1.(A)Clean spearhead holes. 2.Solenoid valve not heating from the spearhead . (B)Check tightness of spearhead properly 2.Solenoid valve assembly . tube. (C) See "LIMING"page 2. 3.Faucet coil is leaking 3.Hot water coil. 2.Be sure spring is in place and any particles are cleaned from valve scat ,If valve sent is mon of...
Need help?
Do you have a question about the MRC3AF and is the answer not in the manual?
Questions and answers