Maintenance And Cleaning; Troubleshooting; Technical Specifications - GRE SH70 Instruction Manual

4

Maintenance and Cleaning

Trouble Shooting
Problems:

The pool does not get warm
Cause/ solution:
a)
b)
c)
d)
e)

No bubbles appear after the equipment has been attached to the pump
Cause/ solution:
a)

Air bubbles come out of the pool return after the pump has been turned on
Cause/ solution:
a)
b)

Water is escaping
Cause/ solution:
a)
b)
c)
5

Technical Specifications

Dimensions: (L x W x H) 72x46x11 cm
 Maximum pressure - 1 bar at 20°C
 Water flow rate - max. 10,000 l/h
 Water content collector - 7L
Heat Output
Standard figures for heating your swimming pool*
1m³ water - 1 day - max. 5.5°C
14m³ water - 1 day - max. 0.4°C
14m³ water - 5 days - max. 2.0°C
NOTE: Results based on 10 hours of direct sunshine per day and may vary due to weather changes. The pool is covered with a
solar cover and the outside temperature approximately 20°C.
Make sure that the water is flowing through the hoses.
Has it been sunny enough?
Ensure the maximum amount of sunlight and increase the running time of the filter pump.
Cover your pool overnight to avoid loss of heat.
It is possible that you may need more than one solar collector.
Check the filter system and ensure that water from the pool is flowing through the filter pump, then through the
solar collector and finally through the connector hose back to the pool.
Check the connector hoses for any damage.
Check that the hose clamps have been properly tightened.
Check the seals in the pipe system.
Check whether you have tightened the hose clamps firmly enough.
Check the connector hoses for any cracks or damages.
8