Subscribe to Our Youtube Channel
Summary of Contents for ESC ELMARK ELFS10
- Page 1 INSTRUCTION FOR FLOAT SWITCH CONTROL OF ELECTRICAL PUMP ESC CODE: ELFS10 PO BOX 816, Hamilton 3240 sales@electrical.co.nz 4-8 Mainstreet Place +64 7 849 9119 Hamilton 3200 0800 350 000...
- Page 2 The device connected to an electrical pump through an electrical cable is used for the auto-control and no water protection of the water tower and water tanks 1. The power supply cable is an integrate part of the device. Should the cable be found to be damaged the device is to be replaced.
- Page 3 Instruction for water-filling operation: Fig 1 Fig 2 Fig 3 Connect the black cable of the floating control to the line phase connection and the blue wire to the electrical pump as shown in Fig.1 for water filling operation (The brown cable shall be kept insulated).
- Page 4 Fig.8:Peel the plastic ring off the counterweight before installation and set thering around the cable, then insert the cable from the conic part into the counterweight and fix it with moderate pressure at the fixing end. Fig 8 PO BOX 816, Hamilton 3240 sales@electrical.co.nz 4-8 Mainstreet Place +64 7 849 9119...
Need help?
Do you have a question about the ELMARK ELFS10 and is the answer not in the manual?
Questions and answers