Greencut JET-4800SX Instruction Manual page 73

1. Pump inlet
2. Pump outlet
3. Detergent port
4. Oil filling system / Filling plug
5. Oil level sight glass
6. Oil drain plug
7. Pressure output adjustment valve
MANGUERAS Y ACCESORIOS
TURBO-HEAD ASSEMBLY
If the "turbo head" and turbo-head is not assembled, 1) wrap the threaded part of the turbo-head adaptor fitting
with plumbers Teflon tape (not supplied), then 2) screw the adaptor into the turbo-head, then 3) use an Allen key
through the adaptor to tighten it firmly to the turbo-head.
"QUICK-CONNECT" TYPE CONNECTORS
1. Ensure the connectors are clean.
2. Pull back on the knurled ring until the ball bearings are visible and hold it in this position, then insert the male
connector into the female. When the parts are fully connected, release the knurled ring.
4
6
1
7
7
3
2
73
EN
3
2
1
5