Advertisement
ATTENTION! Note the direction when you paste the bracket.
5. Install the other bracket on the top edge of the eDP panel. Make sure the
screen is facing the same side as the sticker.
Please note the direction as shown below.
Top Edge
Screen Side
6. Peel the blue plastic liner off. Do not touch the adhesive surface.
Note: Do not peel off the black strip behind the blue plastic liner.
7. Hold the sides of the eDP panel assembly. Obliquely insert it into the groove
of the bottom bracket. Then carefully push it toward the glass panel until the
top bracket is firmly adhered.
If you install them correctly, from the screen side, the silver mylar at the
bottom of the eDP panel will be fully covered by the bracket.
eDP Panel
(Screen Side)
Bottom Edge
(with silver mylar)
B
Screen Side
A
eDP Panel
(Screen Side)
silver mylar
8. Peel off the paper liners from the rubber strips. Do not touch the adhesive
surface. Paste the rubber strips closely along the edges of the eDP panel, so
that the eDP panel is securely framed and won't shift or slide.
Rubber
ATTENTION! Do not paste the rubber strip onto the black strip at
the bracket end, so you can grasp and stretch the black strip to easily
remove the bracket when needed.
Rubber
Black Strip (on the bracket)
9. Connect the smaller end of the eDP cable to the eDP panel.
To do so, open the cover on the flip-lock connector. Insert it into the
connector on the back of the eDP panel. Then close the cover on the
connector to secure it in place.
10. Connect the other end of the cable to the 40-pin eDP connector on the
motherboard.
Note: For easier cable routing, we sugguest you first connect the eDP cable to your motherboard
before installing the motherboard into the case.
11. You can use the cable clips to manage your cable. It's done.
Before using your side panel, please set "Primary Graphics Adapter" to "Onboard" in
the BIOS settings to ensure the display work properly. To do so, please go to "Advanced"
> "Chipset Configuration" and set "Primary Graphics Adapter" to "Onboard". Then
save the settings and restart the system.
Rubber
eDP Panel
Rubber
A
B
Advertisement
