Advertisement
Access & Power Integration
T1HCK3
Up to 8 Door Kit
Fully assembled kit includes:
- Trove1 enclosure with THC1 Altronix/Hartmann Controls backplane
- One (1) AL600ULXB - Power Supply/Charger
T1HCK34
Up to 8 Door Kit with Fused Outputs
Fully assembled kit includes:
- Trove1 enclosure with THC1 Altronix/Hartmann Controls backplane
- One (1) AL600ULXB - Power Supply/Charger
- One (1) ACM4 - Fused Access Power Controller
All components of these Trove kits are UL Listed sub-assemblies.
Please refer to the included corresponding Sub-Assembly Installation Guides for further information.
Installation Guide
All registered trademarks are property of their respective owners.
Rev. T1HCL011122
Installing Company: _________________________ Service Rep. Name: __________________________________________
Address: _________________________________________________________ Phone #: _________________________
Advertisement
Table of Contents
Summary of Contents for Hartmann T1HCK3
- Page 1 Access & Power Integration T1HCK3 Up to 8 Door Kit Fully assembled kit includes: - Trove1 enclosure with THC1 Altronix/Hartmann Controls backplane - One (1) AL600ULXB - Power Supply/Charger T1HCK34 Up to 8 Door Kit with Fused Outputs Fully assembled kit includes:...
- Page 2 Altronix/Hartmann Controls Trove kits are pre-assembled and consist of Trove enclosure with factory installed Altronix power supply/chargers and sub-assemblies. Each kit also accommodates one (1) Hartmann Controls PRS_Master boards and up to four (4) PRS_TDM or PRS_IO8 boards. Configuration Chart:...
- Page 3 1. Align the Hartmann Controls boards on the backplane to match the boards’ mounting holes with corresponding pems. 2. Fasten spacers (provided) to pems that match the hole pattern for Hartmann Control boards (Fig. 2, 2a, pg. 3). Note: Hartmann Controls boards must be properly grounded.
- Page 4 1. Align the Hartmann Controls boards on the backplane to match the boards’ mounting holes with corresponding pems. 2. Fasten spacers (provided) to pems that match the hole pattern for Hartmann Control boards (Fig. 3, 3a, pg. 4). Note: Hartmann Controls boards must be properly grounded.
- Page 5 Notes: THC1 ULXB Kits Installation Guide - 5 -...
- Page 6 Notes: - 6 - THC1 ULXB Kits Installation Guide...
- Page 7 Notes: THC1 ULXB Kits Installation Guide - 7 -...
- Page 8 4.5” (114.3mm) (69.9mm) 1.115” (28.3mm) 1.36” (34.5mm) 1.25” (31.8mm) Hartmann Controls is not responsible for any typographical errors. ––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––– 10 Lockhart Rd, Barrie, ON L4N 9G8, Canada | phone: 1-877-411-0101 web site: www.hartmann-controls.com | e-mail: sales@hartmann-controls.com IITHC1 ULXB Kit Series...
Need help?
Do you have a question about the T1HCK3 and is the answer not in the manual?
Questions and answers