Download Print this page

Warmrails Wonderbar Manual page 2

Portable heated towel rail

Advertisement

::
bathroomsource
INSTALLATION
Remove the Wonderbar™ from the
carton and lay flat on the floor or a table.
It should look like this: (Fig.1)
Make sure all pieces are present.
(Do not try to install the Wonderbar™ if
any parts are missing. Contact customer
service for replacement parts.)
Locate the two hanging clips and
rotate them through 180 degrees so the
hanging clips are at the top. (Fig. 2)
Slide the locking wires down and
place the hanging clips over an existing
towel bar. (Fig. 3) Ensure the hanging
clips fit completely and entirely around
the towel bar. Raise the locking wire and
'snap' it into place. Do not install the
Wonderbar™ in any location where it is
unable to be secured properly or if the
locking wires are unable to be 'snapped'
into the correct closed position.
Plug the cord into a 120V outlet
Your Wonderbar™ will start to heat
up almost immediately. The temperature
will be higher in areas where the
Wonderbar™ is covered by towels or
garments
.com
Call 1-800-667-8721 anywhere in the US and Canada -
Warmrails at
IMPORTANT IMFORMATION
WARNINGS
Your Wonderbar™ Warmrail & drying rack is not a toy. It will heat up
and may appear hot to the touch. It is safe to leave your warm rail
running continuously 24 hours a day, but it should be used responsibly
at all times.
Do NOT immerse the Wonderbar™ in water or any other liquid. The
Wonderbar™ should not be installed in a location where it comes into
contact with water or could accidentally be splashed or immersed in
water or other liquids.
HIGH OPERATING TEMPERATURE:
This towel warmer operates at high temperatures that can cause burns.
Do not touch surfaces of the towel warmer while the warmer is in
operation.
Do not allow unsupervised children in the vicinity of the towel warmer,
and warn children of hot surfaces.
TO AVOID THE POSSIBILITY OF ELECTROCUTION:
Do not immerse towel warmer in water or any other liquid.
Do not place towel warmer in a location where it may fall into a tub or
shower, or otherwise become immersed in water; and if the towel
warmer falls into water, immediately unplug it. Do not reach into the
water.
SAFETY NOTICES
This product is hot when in use. The Wonderbar™ is designed so that
the surface temperatures are within the requirements of the UL
Standard applicable for Miscellaneous Heaters.
Particular care should be taken in confined areas where accidental or
prolonged contact with the Wonderbar™ may be more likely to occur.
If the Wonderbar™ is to be installed in a place where the public can
access it, a warning notice should be place adjacent to the
Wonderbar™ advising that the surface can be hot.
bathroom::accessories
U
N
L
I
M
I
T
E
D
www.bathroomsource.com

Advertisement

loading