Weefine Solar Flare 13000 User Manual

Solar Flare 13000
USER MANUAL
13000 Lumens
Waterproof to
Standard Accessories
Solar Flare 13000
YS Adapter + Ball mount
Specification
Brightness 13000 lumens flood
Depth Rating 100m / 330ft
Beam Angle 120 degree on land 120 underwater
Color Temperature 5600K, Ra=90
Power Level 100% / 80% / 60% / 40% / 20% / 300 lumens
Button Dual push button with battery level indicator
Burn Time Approx. 60 minutes (100% flood)
Battery 8 * 18650 wrapped to single cell (6800mAh 14.4V 97.27Wh)
Charge Time 4 hours
Dimensions 73 (D) * 234 (L)
Weight 1100g (on land) ; 665g (underwater )
Flood.
100m/330ft
Charger Lithium-ion battery
O-rings (11pcs) Hand pump
Features
Right button
Safe valve
Remote control port
Battery Installation and Removal
1. Open the rear cover of the battery canister, and put the lithium battery pack
into the battery canister (as shown in the figure); pay attention to the front of the
battery contact ring, and then tighten the battery canister;
2. To take out the battery (if the flashlight has been vacuumed before), you need
to release the pressure first; unscrew the air vent sealing cover, pull the yellow
sealant plug, and after hearing the sound of air intake, unscrew the battery
canister smoothly and take out the battery.
Battery Contact Ring
Operating the light
Turn ON:
In the off state, press the left and right buttons at the same time for 0.5 seconds to
turn on the power, short press the left button to enter the working mode, the
brightness is 100%.
Turn OFF:
In any mode, under any brightness, press and hold the left and right buttons at
the same time for more than 2 seconds until it is turned off.
Adjusting the brightness:
To increase the brightness：Press and immediately release the right button.
To decrease the brightness：Press and immediately release the left button.
100% 80% 60%
Tail cap
Left button
YS Adapter
Vacuum port
Strobe Port
Yellow Sealant Plug
40% 20% 300Lumens