PiXORD PM342E Quick Installation Manual

PM342E
Step1. Check the package contents
x 2 x 1
PoE Ethernet Extender Power Cord
Step2. Product Appearance
PoE Ports(RJ-45)x4
1
Front Panel
Telephone line
2
1
3 2 (RJ11)+Terminal Block
DIP Switch
3
4
LED indicator
4
( Remote site)
Back Panel
AC Power Jack
5
6 Frame ground
6
( Remote site)
1. PoE Network connectors(RJ45):Provides 4 PoE port to support 4 PoE network devices that meet
IEEE802.3af standard.
Telephone line connectors(RJ-11) and Terminal Block:The PM342E are working in pair.
2.
A telephone line / twisted pair links the two PM342E, so that they can communicate to each other.
3. DIP switch
Default
★ DIP 1
Functions
CPE/CO
ON CPE
OFF
CO
PoE Ethernet Extender
x 4
Terminal Block
Device Mounting Kit
x 12
Screws
1
3
4
( Local site)
6
( Local site)
DIP 2 DIP 3
Transmission Mode1 Transmission Mode2 S/N
Fast Asymmetric
★ ★
Interleave
Symmetric
4. 1/2/3/4 LEDs:Description of link LED status:
LED
Status
x 2
Description of all LEDs status:
LED\Status
PW
CPE
Link
5. AC Power Jack:AC 90V~240V
6. Frame ground:Grounding connection to protect from lightning.
2
Step3. Installation
5
1 Set Remote Site PM342E DIP1 switch to "Off" Local Site PM342E DIP1 switch to "On".
2 Connect two PM342E with phone line cord or twisted pair.
3 Connect power cord to local site of PM342E and switch ON.
-The "PW" LED is "On".
-The "CPE" LED for Remote Site PM342E will be "Off" while the other one is "On".
-The "LINK" LED for both PM342E will be slow flashing at this point and then become solid "On" which
DIP 4
indicates the two PM342E are connected by twisted pair cable .
(It will take 3 minutes to estanblish connection of two devices)
6 dB
★
4 Connect LAN port to a network device for each side of PM342E.
9 dB
Quick Installation Guide
Off Flashing On
No Link Data Transmitting Idle
Off On
Power on
Power off
CO CPE
Connected
Remote site
(CO)
2
Flashing
Connecting
Local site
3
(CPE)
V1.3