MAXDORF CLASSIC Series Manual

Fixed wall installation

Advertisement

1. Product Features:

MD-M3978 Product weight: 1.5kg ; TV size support: 37"- 80"; Maximum load: 50kg; For
Vesa Standard 600 x 400mm ; Distance to the wall: 20 mm

2. Hardware List:

(The below hardware is not included with the purchase of this product.)
I. 6mm spanner II. 10mm spanner III. 8mm star screw driver IV. 8mm star screw driver
V. 8mm spanner VI. 8mm star screw driver VII. 6mm star screw driver
Important:
The Supplier and /or Manufacturer will not be held liable for any personal injury
or product damage due to mishandling, incorrect mounting, incorrect assembly or incorrect use
of this product.
Note:
The supplied wall mounting hardware is not for use on steel stud walls or cold cinder
block walls. If you are uncertain what material your wall is constructed of or have any
questions regarding the proper installation of this wall mount, contact a qualified contractor. If
the hardware required is not included, please contact your local hardware store.
Caution:
This LCD/Plasma wall mount is intended for use on a LCD/LED/Plasma television
that does not exceed the maximum designated weight capacity. Using this mount with products
heavier than the maximum weight indicated may result in instability causing possible injury.
Disclaimer
Without Prejudice of Rights
In order to indemnify the Supplier and/ or Manufacturer please note that once this product is
purchased the Client/ Purchaser agrees to the following:
Should the product .in an unlikely event, fail to operate according to its purpose,Interfoto CC
hereby declare to repair or replace any part of the mechanism which is found to be defective after
a full investigation as to the cause. In the case of defects occurring due to an external third party
and / or the Client / Purchaser installing it incorrectly, misuse or overloading and/ or using it for
any other purpose other than that for which it was intended, neglect or damage, external parties
repairing or modifying the mechanism in any way and or its spare parts, if the enclosed operating
instructions were not followed, the Supplier and /or Manufacturer shall not be held liable for any
damage caused to the product placed on the mechanism or wall which the mechanism is attached
to or any other property and personal injury.
Note: Proof of purchase to be produced for any claim. This product carries a twelve year warranty
for manufacture faults/failures.
CLASSIC SERIES

Parts list

MD-M3978
Fixed wall installation
No.

Important Safety Instructions

Check your TV user manual instructions to see if there are any special requirements for
mounting your TV. If you do not understand these instructions or have doubts about the
safety of the installation, assembly or use of this product, contact:
INTERFOTO CC
Email: service@interfoto.co.za
Address: 362 Roan Crescent,
Corporate Park North, Midrand
Tel: +2786 006 1046
Description
Specifications Model
Wall plate
Arm
Antenna
M4.8x32mm Wallboard screw
M8 Plastic screw
M6x30mm Cross round screw
M8x30mm Cross round screw
Ф6 Washer
Ф8 Plastic spacer
Spirit level
Qty.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CLASSIC Series and is the answer not in the manual?

Questions and answers

Summary of Contents for MAXDORF CLASSIC Series

  • Page 1 CLASSIC SERIES Parts list MD-M3978 Fixed wall installation Description Specifications Model Qty. 1. Product Features: MD-M3978 Product weight: 1.5kg ; TV size support: 37”- 80”; Maximum load: 50kg; For Vesa Standard 600 x 400mm ; Distance to the wall: 20 mm Wall plate 2.
  • Page 2 Instructions for installation Use the spirit level to ensure the wall plate is level, then Pre-drill 6 holes with a 10mm bit (50mm deep.) Insert wall anchors (B) into the holes, then use long bolts (A) to mount the wall plate to wall Under the direction of the arrow, Install the anrtenna hole into the metal Under the direction of the arrow, place the...

This manual is also suitable for:

Md-m3978

Table of Contents