Advertisement
Quick Links
ECDM-100 Sensor Cleaning Guide
©2023 Triton Systems of Delaware, LLC. All Rights Reserved. ATMGurus®, the ATMGurus logo and tag-
line, Triton®, and the Triton logo are all registered trademarks of Triton Systems of Delaware, LLC. e third
party trademarks that may be identi ed herein are the trademark of their respective owners. Triton disclaims any
affi liation, connection, or association between its products and services, and those of the respective trademark
owners, or any sponsorship or approval of its products and services by such trademark owners.
TDN 07103-43001
Rev A
Advertisement
Summary of Contents for Triton atmgurus ECDM-100
- Page 1 ©2023 Triton Systems of Delaware, LLC. All Rights Reserved. ATMGurus®, the ATMGurus logo and tag- line, Triton®, and the Triton logo are all registered trademarks of Triton Systems of Delaware, LLC. e third party trademarks that may be identi ed herein are the trademark of their respective owners. Triton disclaims any affi...
- Page 2 is guide describes how to clean the ECDM-100 cash dispenser. is manual applies to all service personnel involved in maintaining Triton ECDM-100 dispensers nationwide and abroad. is guide provides component locations that should be inspected and/or cleaned with air, alcohol, or swab.
-
Page 3: Materials Required
SAFETY INFORMATION Referenced from the Unit Front, the manual transport Blue Drive Wheel is located on the right side of the unit. ECDM C Triton Systems © TDN 07103-43001 Rev A... - Page 4 #2 = Eject Sensor • #3 = Right Diverter Sensor • #4 = Le Diverter sensor 8. Locate the latch points for the (Front) Upper Guide door, two arrows. Pull/Push latch bar in direction Triton Systems © TDN 07103-43001 Rev A...
- Page 5 Drive Wheel in the OPPOSITE direction of the drive wheel arrow (Clockwise). is action will turn the Reject Press Rollers. Turning the Drive Wheel in direction of arrow will NOT turn the rollers. Triton Systems © TDN 07103-43001 Rev A...
- Page 6 Dab a small section of the cloth in alcohol and hold it against each roller as user turns the Blue Drive Wheel. 18. Dab a cotton tip in alcohol and swab the LEDs for the L/R Diverter Receivers and L/R Diverter Emitters, circles, Right Image. Triton Systems © TDN 07103-43001 Rev A...
- Page 7 Drive Wheel on side of unit. Blue Drive Wheel on right side when facing cassettes 22. Dab a cotton tip in alcohol and hold against Le and Right Lower Rollers, Image below, user turns the Blue Drive Wheel. Triton Systems © TDN 07103-43001 Rev A...
- Page 8 6. Lower Right Note Feeding Roller 16. Roller Guide 7. Le Note Feeding Roller 17. Le Near-End Receiver Sensor 8. Right Note Feeding Roller 9. Cassette Le Pickup Feeding Roller 10. Cassette Right Pickup Feeding Roller Triton Systems © TDN 07103-43001 Rev A...
- Page 9 32. Dab a small section of the cloth in alcohol and hold it against each Note Rollers (11,12) as user turns the Blue Drive Wheel. NOTE: Note Rollers in image show the lack of a proper cleaning. Triton Systems © TDN 07103-43001 Rev A...
- Page 10 35. Turn Unit upside down as shown for the two images below. Use a ash light to shine the Emitter lens. e numbers are for reference to locate the RVST emitters, Le Image. 36. Dab a cotton tip in alcohol and swab the LEDs for the Le /Right RVST Emitters, Right Image, Circles. Triton Systems © TDN 07103-43001 Rev A...
- Page 11 Emitter on bottom, Receiver on top. 41. Inspect the ECDM/Cassette Data Port for bent or damaged contact pins, two (2) on top, six (6) on bottom. Triton Systems © TDN 07103-43001 Rev A...
- Page 12 47. Le image shows cash in the cassette, Right image shows no cash. ese opening show what the corresponding (17) Le / (15) Right Near-End Sensors on the ECDM chassis would see. Triton Systems © TDN 07103-43001 Rev A...
- Page 13 53. Attach the power and communications cable to the dispenser. Slide dispenser tray into cabinet. 54. Power up the ATM. Via the Management Functions menu perform an ECDM test dispenser. E C P Triton Systems © TDN 07103-43001 Rev A...
Need help?
Do you have a question about the atmgurus ECDM-100 and is the answer not in the manual?
Questions and answers