Download Print this page

FEB Easy 9314 Quick Start Manual

Flexi wireless button

Download this manual

9314 - Flexì wireless button

1- Safety warning

Warning: Failure to follow the safety guidelines provided below could result in damage to your

Wireless Push Button or other property. Read all safety information below before using the Wireless

Button.

• Avoid high humidity or extreme temperatures;

• Avoid prolonged exposure to sunlight or intense UV light;

• Do not drop or do not subject the unit to strong vibrations;

• Do not disassemble or try to repair the unit;

• Do not bring into contact with ammable liquids, gases and other explosive substances.

2 - Welcome

We present your Wireless Button 9314.

This button is self-powered by a small piezoelectric circuit and allows you to control the actuators of

the FEB Easy series without ever having to worry about changing the batteries.

It is possible to use a single button to control more than one actuator and to use several buttons to

control the same actuator.

In this guide you will nd an overview of the product and instructions for installation and start-up.

Page 1 This button is self-powered by a small piezoelectric circuit and allows you to control the actuators of the FEB Easy series without ever having to worry about changing the batteries. It is possible to use a single button to control more than one actuator and to use several buttons to control the same actuator.
Page 2 Button 9314 with key cover installed 4 - Installation The FEB Easy 9314 button can be installed simply by snap tting it in a FEB Flexì support. 5 – Start up  To pair the pushbutton 9314 with a FEB Easy actuator, simply press the actuator pairing button for about 3 seconds, until the LED indicator starts ashing, at this point press the 9314 button you want to pair.
Page 3  To reset a connection between the actuator and the buttons, press the actuator pairing button for about 12 seconds. When the button is pressed, the LED indicator will rst begin to ash, it will remain lit brie y and then go oﬀ. When this sequence is complete and the LED is oﬀ, the pairing button can be released and the actuator and all the buttons it was paired with will be disconnected.