Page 2
Squiggle Board Inside Front Cover - Blank Squiggle Board Manual 342-0069 Rev. C Page 2 of 16...
Page 3
Read and understand all instructions before using. Do not operate any device if it has been dropped or damaged. In this case, a Vaddio technician must examine the product before operating. To reduce the risk of electric shock, do not immerse in water or other liquids and avoid extremely humid conditions.
Page 4
Squiggle Board UNPACKING: Carefully remove the device and all of the parts from the packaging and identify the following parts: • One (1) Squiggle whiteboard (4’ x 6’ or 4’ x 8’) with Digital Control Panel installed • One (1) Squiggle Quick-Connect Interface •...
Page 5
The DVI-D and YPbPr outputs are simultaneous outputs and are at a resolution of 720p/59.94 or 720p/50 which allows the Squiggle Board to be connected to a variety of video devices such as Vaddio switchers/mixers, videoconferencing codecs, monitors and other third-party video devices.
Note: Vaddio supplies necessary hardware for mounting the whiteboard to standard drywall. Installation of the whiteboard on masonry or other walls requires specialized mounting screws, available through construction hardware suppliers. Ensure that all clips/hangers are level, when attaching them to the wall.
Squiggle Board Installation (continued): Step 3B: If the Cat. 5e cable is to be surfaced mounted, install Panduit® or some other type of conduit (not included) on the wall to the corner below the electronic receiver side of the whiteboard. On the marker tray end cap, there is a 7/8”...
Page 8
The Color Bars are a video testing convenience only. Using the Squiggle Board: Upon connection and powering up the Squiggle Quick-Connect Interface, the System will boot up and the Vaddio splash screen will be seen on the 720p or SD display device.
Page 9
Squiggle Board Using the Squiggle Board (continued): The system will load the default 4’ x 6’ calibration size. It is recommended that if you have a 4’ x 6’ whiteboard, perform the calibration process anyway. The 4’ x 8’ whiteboard, or any other size, requires calibration. The process to calibrate the system is as follows: 1) Touch the Calibration button on the Digital Control Panel and the following screen is displayed.
Squiggle Board FOR BEST RESULTS: Pen & Eraser Etiquette: The Squiggle Board Pen Holder is the device that is tracked by the ultra sonic sensors and the IR sensor. In order to achieve the best results, adhere to the following guidelines. •...
Page 11
Squiggle Board Sample Wiring Diagram of Squiggle Board to Peripheral Devices: Squiggle Board with Digital Control Panel - (1/2g )R + g Λ = (8πG/c µ ѵ µ ѵ µ ѵ µ ѵ The constant Λ is the cosmological constant; the energy conservation law is unaffected -1/2(R g µ...
Page 12
Squiggle Board Squiggle Board Dimensions: Squiggle Board Manual 342-0069 Rev. C Page 12 of 16...
Page 13
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference including interference that may cause undesired operation of the device. Changes or modifications not expressly approved by Vaddio can affect emission compliance and could void the user’s authority to operate this equipment.
Page 14
Vaddio Customer Service - Vaddio will test, repair, or replace the product or products without charge if the unit is under warranty and is found to be defective. If the product is out of warranty, Vaddio will test then repair the product or products.
Page 15
Squiggle Board Inside Back Cover (blank) Squiggle Board Manual 342-0069 Rev. C Page 15 of 16...