Page 2
In the Box 1 x solar panel 3 x screws 3 x wall anchors (with micro USB cable) 1 x solar panel mount 1 x back plate Need help? Send us an email at: contact@wasserstein-home.com Page 1...
Safety Information • Disassembling the solar panel is not recommended as it may cause damage to internal components. The solar panel may not function properly after disassembly. • Do NOT leave bare wires exposed. Pre-Installation 1. Make sure your solar panel has been charged in direct sunlight for at least 10 hours.
Installation 1. Attach the wires to the back of your doorbell. The red wire connects to the right screw. The black wire connects to the left screw. 2. Mount our backplate on the wall by the two anchors and two screws provided.
Page 5
3. Use the key that comes with your Blink doorbell to remove the backplate. 4. Remove any AA batteries from the Blink doorbell. Page 4...
Page 6
5. Attach the new backplate to the Blink doorbell. 6. Push the doorbell down gently and it will snap onto the backplate. Page 5...
Important Tips The solar panel's energy output depends on sunlight exposure, weather conditions, etc. To maximize the energy output, remember to do the following: • Before installing your doorbell, charge the solar panel for at least 10 hours. • Install your solar panel in an area that receives maximum sunlight. •...
Page 8
Get More Support Scan the QR code below or email us at contact@wasserstein-home.com. Blink Doorbell is not included. Wasserstein is not affiliated with Immedia Semiconductor Inc. www.wasserstein-home.com Wasserstein is a trademark of Dropcases Ltd. Blink Outdoor is a trademark of Immedia Semiconductor Inc.
Need help?
Do you have a question about the Blink Doorbell Solar Panel and is the answer not in the manual?
Questions and answers